ABB Inora 1 Gang 1 Way 10AX Switch Starry Black BL101-885

“1 gang” means the plate contains one switch control, while “1 way” means it operates a circuit from a single switching point. The 10AX designation indicates a 10A switch rating with additional suitability for certain inductive or fluorescent lighting loads. Actual load suitability must also account for the lamp driver, power factor and switching inrush current.

It is intended for standard building lighting applications and can be considered for UAE projects operating on the typical 230V, 50Hz low-voltage supply. Final selection and installation should follow the project specification, local authority requirements, applicable UAE wiring regulations and the instructions supplied by ABB.

The switch is suitable for controlling a single lighting circuit in villas, apartments, offices, retail spaces, hotels and other buildings. Typical uses include bedroom, corridor, living-room, storeroom and office lighting where control is required from only one location.

It may be used with compatible LED lighting circuits, but the total wattage alone should not determine suitability. LED drivers can create high startup or inrush currents, so contractors should verify the driver characteristics, connected quantity and ABB load guidance. A suitably rated contactor or control device may be needed for larger lighting groups.

No. The BL101-885 is a one-way switch intended to control one circuit from one point. For staircase, corridor or room layouts requiring control from two locations, use compatible two-way switches and the correct wiring arrangement.

Installation should be completed by a qualified electrician. The circuit must be isolated and verified dead before work begins. The electrician should confirm the terminal identification, connect the incoming live conductor and switched-live conductor as shown in ABB's wiring instructions, secure the mechanism in a compatible wall box, fit the front plate and test polarity, insulation, continuity and switch operation before energising.

A conventional mechanical one-way switch normally interrupts the live conductor and generally does not require a neutral at the switch mechanism. However, the electrician must inspect the actual product terminals and follow the approved wiring diagram. Neutral and protective-earth conductors must be handled according to the circuit design and local wiring requirements.

Check the model number BL101-885, circuit voltage, load type, current demand, LED-driver inrush, wall-box compatibility, mounting depth, conductor size and project finish schedule. Contractors should also inspect the switch for transit damage and confirm that the installation location and environmental conditions are appropriate.

Yes, it is well suited to residential and commercial fit-outs that specify dark electrical accessories. The Starry Black finish can complement modern wall finishes, dark joinery and coordinated interior hardware. Project teams should approve a sample before bulk installation because colour appearance can vary under different lighting conditions.

Do not assume that this standard wall switch is weatherproof or suitable for direct exposure to water, dust or UAE outdoor conditions. For bathrooms, balconies, gardens, plant rooms or external areas, select an enclosure and accessory with an appropriate verified IP rating and install it according to local zoning and electrical-safety requirements.

It is primarily intended for lighting control. Fans, motors, pumps and other inductive equipment can have starting currents that exceed their normal operating current. Use it for such loads only when the equipment characteristics and ABB technical documentation confirm compatibility; otherwise, use a correctly rated isolator, motor controller, relay or contactor.

Isolate the electrical supply before inspection or maintenance. Clean the faceplate with a soft, dry or slightly damp cloth and avoid abrasive pads, solvents and strong chemical cleaners that could damage the finish. Replace the switch if it becomes loose, cracked, overheated, discoloured or unreliable, and have recurring circuit issues checked by a qualified electrician.

The ABB Inora BL101-885 combines straightforward single-point lighting control, a 10AX electrical rating and a contemporary Starry Black appearance. It is a practical specification option for UAE villas, apartments, offices and hospitality fit-outs where an ABB-branded dark-finish wall switch is required, subject to load verification and project compliance approval.