ABB Inora 1 Gang TV Outlet, End-of-Line White BL301

End of line means the outlet is installed at the last point of the TV coaxial cable run rather than between two outlets. It does not pass the signal onward to another point. Correctly selecting an end-of-line outlet helps maintain the intended signal performance and termination arrangement of the distribution system.

The BL301 can be used for fixed TV connection points in villas, apartments, offices, hotels, staff accommodation and other buildings with a compatible coaxial television distribution system. Typical installation locations include living rooms, bedrooms, hotel rooms, meeting rooms and reception areas.

Yes, it is suitable for indoor electrical fit-out and low-current works in UAE residential and commercial projects when specified as part of a compatible TV distribution system. Installation should follow the approved project drawings, local authority requirements, relevant UAE regulations and the consultant's material specifications.

The outlet should be fitted into a compatible single-gang wall box. The installer routes the specified coaxial cable into the box, prepares the cable without damaging its centre conductor or shielding, connects it to the outlet terminal, secures the mechanism and fits the faceplate level with the finished wall. The circuit should then be checked using suitable TV signal-testing equipment. Installation is best completed by a qualified electrical or ELV technician.

Use the coaxial cable specified for the building's television, MATV, SMATV or antenna distribution design. The selected cable should have the correct impedance, shielding, frequency performance and termination method for the system. Cable type and connector compatibility should be confirmed against the project specification and ABB technical documentation before installation.

No. The BL301 is identified as an end-of-line TV outlet and should normally be used only at the final point of a compatible cable run. If the TV network continues to another outlet, a suitable intermediate or loop-through model should be selected according to the system design.

Compatibility with satellite, MATV, SMATV, terrestrial antenna or cable TV systems depends on the outlet's supported frequency range, connector format and the network design. Buyers should verify the required system specification and ABB product data before using the BL301 for a satellite receiver connection.

Contractors should confirm the model number BL301, end-of-line configuration, one-gang format, white finish, wall-box compatibility, coaxial cable specification and required connector type. The outlet should also match the approved wiring accessory range, room schedule, consultant submittal and TV distribution drawings.

The concealed wall box and coaxial conduit are normally installed during first-fix works. Cable pulling and termination may follow as the ELV installation progresses, while the outlet mechanism and white faceplate are generally fitted during final fix after plastering and painting. Protective covers should be used where necessary to prevent dust, paint and construction debris from entering the connection.

Use the specified coaxial cable, respect minimum bending radii, avoid crushing or sharply bending the cable and maintain continuous shielding. Keep TV cabling appropriately separated from power circuits in accordance with project and regulatory requirements. Terminate the centre conductor and screen correctly, avoid loose strands or short circuits and test signal level and quality after installation.

Common causes include loose coaxial terminations, damaged cable, incorrect outlet selection, poor shielding, excessive cable length, unsuitable splitters, incorrect amplifier levels or a fault elsewhere in the distribution system. A qualified technician should inspect the termination and measure the signal at the BL301 outlet rather than replacing components without testing.

This wiring accessory is intended primarily for protected indoor use unless ABB documentation and the project specification confirm a suitable environmental or ingress-protection rating. For balconies, external walls, wash areas or other damp locations, use an appropriately rated weatherproof enclosure or outlet approved for those conditions.

Isolate or disconnect connected equipment where appropriate, then wipe the faceplate with a soft, dry or slightly damp cloth. Do not use abrasive pads, strong solvents or excessive water. Periodically check that the outlet remains secure and arrange professional inspection if the connector becomes loose or TV reception deteriorates.