ABB Inora 2 Gang 13A Double Pole Switched Socket Outlet Royal Gold BL239-PG

DP means double pole. Each switch is designed to isolate both the live and neutral conductors, providing more complete disconnection than a single-pole switch. This is useful for fixed building installations where enhanced isolation and safe control of connected appliances are required.

The socket is rated at 13A per outlet for use on a suitable low-voltage AC circuit. The total connected load must remain within the capacity of the final circuit, protective device, wiring and applicable electrical regulations. A qualified electrician should assess high-load appliances rather than assuming both outlets can continuously carry maximum load at the same time.

Yes, a British-style 13A switched socket is commonly used in UAE residential and commercial projects. Installation must comply with the current UAE electrical requirements, applicable BS/IEC standards and the rules of the relevant local authority or utility, such as DEWA or the responsible authority in the project emirate. Project consultants should verify the product's latest conformity documentation before approval.

It is suitable for dry indoor areas such as bedrooms, living rooms, hotel rooms, executive offices, reception areas, villas and premium retail interiors. The royal gold finish works particularly well with luxury décor, warm metallic accessories and coordinated electrical wiring accessories.

Yes. Model BL239-PG can be specified for new construction, renovation and interior fit-out work requiring a decorative double switched socket. Contractors should coordinate the socket model, finish, back-box arrangement, wiring capacity and accessory schedule before first-fix work to avoid installation conflicts.

Installation should be completed with the circuit isolated and proven dead. The electrician must use a compatible recessed or surface back box, terminate live, neutral and earth conductors at the correctly marked terminals, tighten connections to the manufacturer's specified torque, secure the socket level and test the completed circuit. Installation should only be performed by a qualified electrical professional.

A compatible two-gang back box with sufficient depth for the socket mechanism, conductor bend radius and terminal connections is normally required. Exact box dimensions and minimum depth should be confirmed from the ABB Inora technical datasheet or approved project submittal before wall chasing, blockwork or gypsum-board installation.

Yes. Protective earth continuity is essential for a 13A socket outlet. The circuit protective conductor must be correctly terminated, and any metallic back box must be bonded where required. Earth continuity, polarity, insulation resistance and protective-device operation should be tested before the circuit is energised.

It may be installed in suitable dry indoor kitchen or utility-room locations, provided required clearances from sinks, water sources, heat and cooking equipment are maintained. The circuit must have appropriate protection under the applicable wiring regulations. It should not be installed where direct water spray, condensation or excessive heat is expected unless its verified enclosure rating permits that application.

Do not use it in bathrooms, exposed balconies, gardens or other wet and dusty locations unless ABB documentation confirms the necessary IP rating and the installation complies with the relevant electrical zones. Outdoor and wet-area applications generally require purpose-designed weatherproof sockets with suitable covers, seals and protective devices.

Only appliances fitted with an appropriate 13A plug and operating within the circuit's calculated load should be connected. High-load or fixed equipment such as many air conditioners, storage water heaters and cooking appliances may require a dedicated circuit, isolator or fused connection unit. Follow the appliance manufacturer's instructions and the electrical consultant's load schedule.

The socket circuit should be protected by a correctly selected MCB or RCBO, with residual-current protection provided where required by current regulations and project specifications. Cable size, circuit arrangement, fault level, earthing system and installation method must all be considered by the electrical designer or licensed contractor.

Switch off the circuit before cleaning and wipe the faceplate with a soft, dry or slightly damp cloth. Do not use abrasive pads, metal polish, bleach, solvents or aggressive chemicals, as these may damage the decorative finish. Keep moisture away from the socket apertures and replace the unit if there are signs of overheating, cracking or loose switching.

Verify model number BL239-PG, royal gold finish, 13A double switched configuration, double-pole operation, required quantity and compatibility with the project's back boxes and accessory range. Contractors should also review the approved material submittal, ABB technical documentation, wiring-accessory schedule and local authority requirements before procurement.