ABB Inora 2 Gang TV and RJ11 Telephone Outlet Royal Gold BL324-PG

The 5-1000MHz rating indicates the operating frequency range of the TV outlet. This range is commonly used for terrestrial television, MATV, CATV and other coaxial distribution systems. Actual signal quality depends on the complete network, including the antenna or service feed, coaxial cable, splitters, amplifiers, connectors and termination quality.

Yes. The outlet is designed with separate TV and telephone connection points, allowing both services to be used from the same wall location. The coaxial TV cable and telephone cable must remain correctly separated and terminated behind the outlet to prevent installation errors and maintain reliable performance.

It is suitable for villas, apartments, hotel rooms, serviced residences, offices, reception areas and meeting rooms. The Royal Gold finish works particularly well with decorative interiors, while the combined configuration helps reduce the number of separate wall plates required near televisions, desks and communication points.

Yes, it is relevant to UAE residential and commercial projects that use concealed TV and telephone cabling. Installation should follow the approved project drawings, local authority requirements, consultant specifications and applicable UAE low-current and telecommunications practices. For developments with a nominated telecom provider, confirm the required telephone connector, cabling category and termination method before installation.

Installation should be completed by a qualified electrician or ELV technician. Isolate nearby electrical circuits, prepare a compatible flush or surface mounting box, route and identify the coaxial and telephone cables, terminate each cable at its designated rear terminal, secure the outlet without trapping or sharply bending the cables, and fit the decorative plate. Test the TV signal level and telephone line after installation.

Use a project-approved 75-ohm coaxial cable suitable for the television distribution system. The cable should be routed without tight bends, excessive pulling force or damaged shielding. Correct termination and continuous shielding are important because poor joints can cause signal loss, interference, pixelation or unstable reception.

The telephone side should be connected using the cable type specified for the project, such as an approved twisted-pair telecommunications cable. Confirm the outlet terminal format and pin configuration before termination. If the building uses structured cabling, IP telephony or fibre-based services, check whether this telephone outlet matches the final service interface.

The stated 5-1000MHz range is generally associated with terrestrial, MATV and cable television frequencies. Many direct satellite intermediate-frequency systems operate above 1000MHz, so this outlet should not be assumed suitable for a direct satellite feed. Review the satellite system design and use a correctly rated SAT outlet where higher-frequency support is required.

It may be installed in the same room or accessory arrangement where permitted by the approved design, but power and ELV cables should be segregated in accordance with local regulations, project specifications and good construction practice. Separate conduits or appropriately divided containment can reduce electromagnetic interference and simplify future maintenance.

Confirm the model number BL324-PG, Royal Gold finish, 2 gang configuration, mounting-box compatibility, faceplate dimensions, TV connector format and telephone interface required by the project. Also verify that the 5-1000MHz TV rating matches the building's distribution system and that related ABB Inora accessories use the same finish.

Coordinate the outlet position with furniture layouts, TV mounting heights, joinery, data points and nearby power sockets before wall finishing begins. Provide the correct back box and conduits during the first-fix stage, protect cables during plastering, and complete termination during the second-fix stage. Avoid locations exposed to water, heavy condensation, direct outdoor weather or excessive heat.

Inspect the plate alignment, fixing security and cable terminations first. Test the coaxial point with a suitable TV signal meter to confirm signal level and quality across the required channels. Test the telephone point for correct continuity, pin assignment and service operation. Any poor result should prompt inspection of the cable route, connectors, splitters and upstream distribution equipment.

Switch off or isolate nearby electrical accessories before cleaning. Wipe the faceplate with a soft, dry or slightly damp cloth, then dry it immediately. Do not use abrasive pads, solvents, acidic cleaners or strong chemicals, as these may damage the decorative Royal Gold surface. Periodically check that the outlet remains secure and free from cracked or loose components.