ABB Inora Shaver Socket, 115/230V 20VA Starry Black BL401-885

The product listing references a 230V AC supply, but the complete input and output ratings should be verified from the rating label, packaging or current ABB technical datasheet because the listed title contains abbreviated voltage information. The socket must only be connected to the supply voltage and frequency stated by ABB, and appliances must match the marked output.

It is intended for compatible low-power grooming equipment such as electric shavers and certain electric toothbrush chargers, subject to the socket's marked voltage and maximum load. It must not be used for hair dryers, hair straighteners, heaters, kettles, vacuum cleaners or other high-power appliances. Always check the appliance rating before use.

It can be suitable for UAE residential and commercial bathroom installations when its marked electrical ratings match the local 230V, 50Hz supply and it is installed in an approved bathroom location. The installation must comply with applicable UAE authority requirements, the project's electrical specifications and the relevant provisions of BS 7671 or other standards adopted by the local authority.

The socket should be positioned outside prohibited bathroom zones and away from direct water spray, shower outlets, bathtubs and washbasin splash areas. The exact location and mounting height must be determined by a qualified electrician according to bathroom zoning rules, manufacturer instructions and requirements issued by the relevant UAE authority, such as DEWA, ADDC or the applicable local utility.

Installation should be completed with the circuit isolated and proven dead. A licensed electrician should confirm the correct back-box depth, route and terminate the conductors according to the labelled terminals, verify earthing where required, secure the unit without damaging the faceplate, and complete polarity, insulation resistance, continuity and functional tests before energising it. ABB's installation instructions take precedence over general guidance.

Bathroom electrical circuits commonly require additional residual-current protection, typically in line with the project design and applicable wiring regulations. Whether protection is integrated elsewhere in the distribution system or specifically required for this point must be assessed by the electrical contractor. The selected RCD or RCBO rating and tripping characteristics should comply with local authority and consultant requirements.

Yes, it may be specified for hotel guest bathrooms, serviced apartments, villas, residential towers and suitable commercial washrooms. Before procurement, the contractor or consultant should verify the model's voltage rating, load limit, back-box compatibility, finish schedule, authority approval requirements and coordination with the wider ABB Inora wiring-accessory range.

Contractors should confirm model number BL401-885, the Starry Black finish, rated input and output, maximum permitted load, terminal arrangement, installation depth, compatible mounting box and required quantity. They should also compare the approved material submittal, room data sheets and electrical drawings to avoid mismatches during fit-out.

No. A shaver socket is a specialised outlet for compatible low-power grooming appliances and is not a general-purpose socket. Replacing or converting an existing outlet requires assessment of the circuit, bathroom zone, protective devices, back box and wiring by a qualified electrician. It should never be treated as a substitute for a standard UAE 13A socket outlet.

Switch off the relevant circuit before maintenance, then wipe the faceplate with a soft, dry or slightly damp cloth. Do not use abrasive pads, solvents, acidic cleaners or excessive water, as these may damage the Starry Black surface or enter the electrical assembly. The socket should be inspected if it becomes loose, discoloured, unusually warm, noisy or damaged.

Its Starry Black finish supports contemporary bathroom and hospitality interiors while allowing coordination with compatible dark-coloured ABB Inora switches and sockets. For UAE projects, it offers a purpose-specific grooming appliance outlet, provided that the electrical ratings, bathroom zoning, authority requirements and approved project specifications are all satisfied.