ABB Millenium 13A Double Pole Double Switched Socket Antique Gold AM239147-AG

The socket is rated at 13A and 250V AC and uses a dual BS 13A outlet configuration. It is a flush-mounted, 2-gang switched socket with secure fixed-wiring terminals and double-pole isolation. The listed overall dimensions are 42 x 147 x 86 mm; installers should verify the required back-box dimensions and mounting depth before installation.

Yes. The UAE commonly uses British-style 13A Type G plugs and operates on a nominal 230V, 50Hz electrical supply, making this 250V AC dual BS socket suitable for compatible installations. Final selection and installation must comply with the applicable UAE electrical regulations, project specifications and requirements of the relevant local authority, such as DEWA, ADDC or SEWA.

Double-pole switching disconnects both the live and neutral conductors when the outlet is switched off. This provides more complete local isolation than single-pole switching and can support safer operation and maintenance when the socket is correctly wired by a qualified electrician.

It is suitable for appliances and equipment fitted with compatible BS 13A plugs, including televisions, computers, lamps, small kitchen appliances and general office equipment. The connected load must remain within the outlet, plug, circuit and protective-device ratings. High-load equipment such as electric cookers, water heaters and large air-conditioning units may require dedicated circuits and connection arrangements.

Both outlets may be used simultaneously when the connected loads, branch circuit, cable size and protective device are correctly designed for the application. A qualified electrician should assess the combined demand and circuit capacity rather than assuming that each outlet can continuously supply its maximum rating at the same time.

Installation requires a compatible concealed back box and appropriately sized fixed wiring. After isolating and proving the circuit dead, a qualified electrician should terminate the live, neutral and earth conductors at the marked terminals, secure the mechanism without trapping cables, fit the matching frame and test polarity, earth continuity, insulation resistance and protective-device operation before energising the circuit.

Contractors should confirm the approved electrical layout, circuit load, cable size, protective device, RCD requirements, earthing arrangement, back-box size and finished wall depth. Coordination with blockwork, drywall, joinery, tiling and decorative finishes is important so the socket sits level and flush. The antique gold finish should also be checked against the approved material schedule or interior design sample.

A compatible flush back box with adequate width, fixing centres and internal depth is required. The listed product dimensions are 42 x 147 x 86 mm, but these should not be treated as confirmed back-box cut-out dimensions. Verify compatibility with the selected ABB Millenium mechanism, frame, cable bend radius and wall construction before closing the wall.

It can be considered for suitable indoor kitchen locations when installed away from excessive heat, water and steam and when the circuit has the required protection. Bathroom installation is subject to strict electrical zones, local regulations and project requirements. Because no IP rating is specified in the supplied product data, it should not be assumed to be water-resistant or suitable for wet zones.

Not unless the installation provides an appropriately rated weatherproof enclosure and complies with local electrical requirements. No outdoor or ingress-protection rating is stated for this model, so it is primarily suited to dry indoor environments. UAE outdoor installations require careful consideration of dust, humidity, heat, water exposure and UV conditions.

RCD or RCBO protection is commonly required or specified for socket-outlet circuits, depending on the location, circuit design and applicable regulations. The socket itself does not replace circuit protection. A qualified electrical contractor should select the correct protective device and verify compliance with UAE authority requirements and relevant standards such as BS 7671 where adopted by the project.

Keep the decorative faceplate covered until dusty, wet and abrasive work is complete. Avoid contact with cement, grout, paint, solvents and harsh cleaning chemicals. Clean only with a soft, dry or slightly damp cloth, and do not use abrasive pads or metal polish unless specifically approved by ABB, as these may damage or alter the finish.

This model combines a commonly used dual BS 13A outlet format with double-pole switching, concealed wiring and a coordinated antique gold finish. It is well suited to premium villas, apartments, hotels, offices and retail interiors where electrical functionality, local plug compatibility and a consistent decorative specification are important.