ABB Millenium 13A Double Pole Double Switched Socket Stainless Steel AM239147-ST

Double-pole switching disconnects both the live and neutral conductors when the socket is switched off. This provides more complete local isolation than single-pole switching, subject to correct wiring and earthing. The protective earth connection remains continuous and must not be switched.

Yes, its 250V AC rating and BS-style 13A socket configuration are suitable for many UAE low-voltage installations, where Type G plugs are commonly used. Selection and installation must comply with the applicable UAE electrical authority requirements, project specifications and current wiring regulations.

It can supply compatible BS 13A plug-connected equipment such as televisions, computers, chargers, small kitchen appliances and office equipment. The connected load, circuit capacity, cable size and protective device rating must all be checked. High-load equipment should only be connected where the circuit design and manufacturer instructions permit it.

Both outlets can be used simultaneously when the total connected demand remains within the limits of the socket assembly, branch circuit, cable and protective device. Do not assume that two outlets double the circuit capacity. Confirm the permitted loading in the ABB technical documentation and the approved electrical design.

The socket is intended for flush mounting, with the fixed wiring and back box concealed behind the finished wall. Installation generally involves isolating and proving the circuit dead, confirming back-box compatibility, terminating live, neutral and earth conductors at the marked terminals, securing the assembly and frame, and carrying out the required electrical tests before energising.

Yes. A licensed or suitably qualified electrician should install and test the socket. Correct conductor identification, terminal tightening, earthing, polarity, insulation resistance and protective-device coordination are essential for a safe installation and compliance with UAE project and authority requirements.

The listed overall dimensions are approximately 42 x 147 x 86 mm, with a width of 147 mm. The installer must verify the required back-box format, fixing centres and minimum internal depth against the ABB Millenium installation drawing before wall cutting or box installation. Extra depth may be required to accommodate cable bends and terminations without strain.

Yes, it can be incorporated into gypsum partitions, masonry blockwork and concrete wall systems when a compatible flush back box is correctly positioned and securely fixed. On construction projects, the box should be coordinated before wall closing or final plastering so that the finished face remains level and the wiring is not damaged.

It should not be treated as an outdoor or weatherproof socket unless the complete installed assembly has a confirmed IP rating suitable for the location. The stainless steel finish does not by itself provide protection against rain, dust or condensation. UAE outdoor, balcony, wash-area and plant-room installations normally require an appropriately rated enclosure and suitable circuit protection.

All protective earth terminals and any exposed conductive parts that require bonding must be connected in accordance with ABB instructions and the applicable wiring rules. The decorative finish must never be relied upon as an earth path. Earth continuity should be verified during testing before the socket is put into service.

The circuit should use correctly selected overcurrent protection and, where required by UAE regulations or the project specification, residual-current protection such as an RCD or RCBO. Device rating, cable cross-section, installation method, ambient temperature and grouping factors must be assessed by the electrical designer or installer.

Flush mounting conceals the permanent wiring and back box, producing a neat finish suitable for villas, apartments, offices, hotels and retail interiors. It also supports coordinated installation with plaster, tile, joinery and wall finishes, provided the box depth and final surface level are planned during the construction stage.

Switch off and isolate the circuit before maintenance. Clean the faceplate with a soft, lightly damp cloth and avoid abrasive pads, aggressive chemicals and excessive moisture. Periodic inspection by a qualified electrician is recommended if there are signs of heat discolouration, loose operation, cracking, arcing sounds or damaged terminals.

Contractors should confirm the model number AM239147-ST, 13A and 250V AC ratings, dual BS 13A outlet configuration, double-pole switching, stainless steel finish, flush-mounting requirements, compatible back box and matching ABB Millenium frame. They should also check the approved material submittal, circuit schedule and local authority requirements for the project.