ABB Millenium 13A Double Pole Single Switched Socket Matt Gold AM23786-MG

This socket is rated at 13A and 250V AC and uses a BS 13A socket-outlet configuration. It has a double-pole switch, secure cable terminals and a flush-mounted design. Its stated dimensions are 86 x 86 mm, with a listed overall depth of 35 mm. The model number is AM23786-MG.

Double-pole switching disconnects both the live and neutral conductors when the socket is switched off. This provides more complete local isolation than single-pole switching, subject to correct wiring and circuit design. The protective earth conductor remains permanently connected and must not be switched.

Yes, its 13A BS-style socket format and 250V AC rating are appropriate for many UAE projects using the British-pattern plug system and a nominal 230V AC supply. Final selection and installation must comply with the applicable UAE electrical regulations, project specifications and requirements of the relevant authority, such as DEWA, ADDC or the local utility provider.

It is intended for compatible BS 13A fused plugs and appliances whose operating current and load do not exceed the socket, circuit and plug-fuse ratings. Typical uses include televisions, computers, lamps and suitable household or office equipment. High-load appliances should only be connected after confirming their nameplate rating and the capacity of the final circuit.

The unit is designed for flush installation in a compatible wall box, with permanent cabling concealed behind the finished wall. A qualified electrician should isolate and verify the circuit as dead, confirm the box depth and cable condition, terminate live, neutral and earth conductors at the marked terminals, secure the socket level and test polarity, earthing and protective-device operation before energising it.

Contractors should verify the approved electrical drawings, 13A outlet schedule, circuit protection, conductor size, earthing arrangement, wall-box compatibility and available installation depth. The 86 x 86 mm face dimensions should also be coordinated with wall finishes, joinery and adjacent accessories. A sample should be approved where colour matching and alignment are important.

Yes, it can be flush mounted in drywall partitions or masonry walls when a suitable electrical back box and the correct fixing method are used. For drywall, use a box designed for hollow partitions; for blockwork or concrete, use an appropriately embedded box. The box must be level, securely fixed and deep enough for safe conductor bending and terminal clearance.

Suitability depends on the installation zone and environmental protection required. No specific IP rating is stated in the supplied product data, so it should not be assumed to resist water, dust or outdoor weather. In kitchens, bathrooms, balconies or external locations, the designer must assess moisture exposure and select suitable IP-rated accessories, RCD protection and installation positions where required by local regulations.

It may be used on a suitably designed ring or radial final circuit where permitted by the project specification and applicable wiring rules. The circuit conductor size, protective device, fault-loop conditions, voltage drop and connected load must be checked by the electrical designer or licensed electrician rather than determined solely from the socket's 13A rating.

The matt gold finish is primarily decorative and is well suited to premium villas, hotels, offices and modern interior fit-outs. Install it after dusty or wet construction activities where practical, protect the face during painting and clean it with a soft, dry or lightly damp cloth. Avoid abrasives, solvents and aggressive chemicals that could damage the visible finish.

A competent electrician should carry out the tests required by the approved inspection procedure, including protective-conductor continuity, insulation resistance, polarity and applicable earth-fault or RCD tests. The switch should operate correctly, conductors should be securely terminated and the faceplate should sit level without trapped or exposed wiring.

It combines a commonly specified 13A BS socket format, local double-pole control, concealed flush mounting and an architectural matt gold finish. These features make it relevant to UAE villa, apartment, hospitality, retail and commercial fit-outs where coordinated electrical accessories and dependable fixed-wiring connections are required.