ABB Millenium 13A Double Pole Single Switched Socket White Glass AM23786-WG

The socket is rated at 13A and 250V AC and uses a BS 13A socket-outlet configuration. It has a double-pole switching mechanism, secure cable terminals and a flush-mounted installation format. Its overall dimensions are approximately 86 x 86 mm, with a listed depth of 35 mm.

Yes. Its 250V AC rating and BS 13A socket format are compatible with the 230V, 50Hz electrical supply and Type G plug system commonly used in the UAE. The complete installation must still comply with applicable UAE electrical regulations, project specifications and the requirements of the relevant local authority, such as DEWA, ADDC or SEWA.

Double-pole switching disconnects both the live and neutral conductors when the socket is switched off. This provides more complete local isolation than single-pole switching and is useful in residential, commercial and construction projects where enhanced control and safe isolation of connected equipment are required.

It is suitable for compatible BS 13A plug-connected appliances and equipment whose operating current does not exceed the socket rating. Typical applications include televisions, computers, small kitchen appliances, chargers and office equipment. High-load equipment must be checked against its nameplate current and the circuit design before connection.

The socket is designed for flush installation in a compatible concealed wall box. After safely isolating and verifying the circuit is dead, a qualified electrician should terminate the live, neutral and protective earth conductors at the correctly marked terminals, secure the mechanism without trapping cables, fit the matching frame and test polarity, earthing, insulation and switching operation before energising the circuit.

Use a compatible flush back box that suits the 86 x 86 mm face dimensions, the approximately 35 mm product depth and the space needed for cable bends and terminal connections. The installer should verify the exact ABB mounting arrangement and ensure adequate clearance before completing blockwork, plasterboard or wall finishing.

Yes. It is suitable for new villas, apartments, offices, hotels and other interior fit-out projects. Electrical contractors should coordinate the back-box position, conduit entry, cable size, finished wall level and accessory alignment before plastering, tiling or decorative cladding is completed.

It may be used in appropriate dry indoor locations, subject to local wiring rules and project requirements. Do not assume that the decorative white glass finish makes it weatherproof or water-resistant. Installation in wet areas, outdoors or exposed locations requires the correct IP-rated enclosure or accessory, appropriate circuit protection and compliance with prescribed electrical zones.

Yes. Keep the decorative surface protected from cement, plaster, paint, grout, sealants and abrasive tools. Complete dusty construction activities before fitting the final frame where practical, tighten fixings evenly without overtightening and clean the face using a soft, lightly damp cloth. Avoid abrasive pads and aggressive chemical cleaners.

The socket must be connected to a correctly designed final circuit with suitable conductor sizing, overcurrent protection, protective earthing and residual-current protection where required by UAE regulations or the project specification. Circuit design and protective-device selection must be determined by a qualified electrical professional rather than from the socket rating alone.

A qualified electrician should inspect terminal tightness and conductor identification, then verify continuity of protective conductors, insulation resistance, polarity, earth-fault protection and correct double-pole switching. Any required RCD or RCBO operation tests should also be completed, with results documented as part of the project's electrical testing and commissioning records.