ABB Millenium 13A Double Pole Switched Socket with LED White Glass AM23886-WG

This socket has a rated current of 13A and a rated voltage of 250V AC. It uses a BS 13A socket-outlet configuration, provides double-pole switching, includes an LED status indicator and is intended for flush mounting. Its stated dimensions are approximately 35 x 86 x 86 mm, with an 86 mm face width.

Double-pole switching disconnects both the live and neutral conductors when the socket is switched off. This provides more complete local isolation than a single-pole switch, subject to correct wiring and circuit design. The protective earth conductor remains permanently connected and must never be switched.

Yes. Its 250V AC rating and BS 13A socket format are suitable for the voltage supply and British-style plugs commonly used in the UAE. Final selection and installation should comply with the applicable UAE electrical regulations, the relevant emirate's authority requirements and project specifications.

The integrated LED provides a visible indication of the switch or connected-circuit status, helping users confirm operation at a glance. The exact illumination behaviour can depend on the product's internal configuration and wiring method, so the ABB installation instructions should be checked during commissioning.

It is suitable for indoor residential, commercial, hospitality and office applications, including villas, apartments, hotel rooms, meeting rooms and premium interior fit-outs. Typical loads include compatible appliances, electronics and portable equipment whose current demand does not exceed the socket or circuit rating.

Yes. The ABB Millenium socket is suitable for new-build, renovation, MEP and interior fit-out work where a flush-mounted 13A outlet with double-pole control is specified. Contractors should verify the approved material schedule, back-box compatibility, circuit loading, cable size and authority requirements before procurement and installation.

Installation requires a compatible concealed wall box and correctly prepared fixed wiring. With the circuit isolated and proven dead, a qualified electrician should connect the live, neutral and earth conductors to their marked terminals, secure the mechanism without trapping cables, fit the matching frame and faceplate, and then complete electrical safety testing before energising the circuit.

The socket requires a concealed mounting box with suitable dimensions, fixing centres and sufficient depth for the mechanism, conductors and terminal clearances. Because the stated product depth is approximately 35 mm, the electrician should confirm the required box depth and compatibility with the ABB Millenium frame before wall finishing begins.

Cable size and protective-device selection must be determined from the circuit design, installation method, ambient temperature, grouping, voltage drop and applicable UAE regulations. The socket must be connected to an appropriately protected final circuit, and the connected load must not exceed its 13A rating. A qualified electrical engineer or electrician should confirm the design.

It may supply compatible equipment only when the appliance current, plug, cable and circuit protection are all within their approved ratings. Continuous or high-load equipment should be checked against the manufacturer's instructions and the electrical design. Loads above 13A, or appliances requiring a dedicated connection, must not be connected through this socket.

This model is intended primarily for indoor flush-mounted applications. It should not be installed where it may be exposed to rain, water jets, excessive moisture, dust or harsh site conditions unless the complete installation has the required IP protection and is permitted for that location. Wet-area positioning must follow applicable electrical zoning and UAE authority requirements.

A qualified electrician should carry out the tests required by the project and local regulations, which may include protective-conductor continuity, insulation resistance, polarity, earth-fault loop or protective-device verification, RCD operation where applicable, functional switching and LED indication. The outlet should be energised only after satisfactory inspection and testing.

Isolate the power before maintenance and clean the surface with a soft, dry or slightly damp cloth. Do not use abrasive pads, solvents or aggressive chemicals on the glass finish. Periodically check for heat marks, cracks, loose mounting, unusual noise or intermittent operation, and have any defect investigated by a qualified electrician.

The AM23886-WG combines a commonly used UAE 13A socket format with double-pole isolation, LED status indication, secure fixed-wiring terminals and concealed flush installation. Its white glass finish also suits premium residential and commercial interiors where electrical performance and coordinated aesthetics are both important.