ABB Millenium 13A Single Pole Switched Socket Dune Sand AM23386-DU

Yes. Its BS 13A socket configuration is compatible with the Type G plug format commonly used in the UAE, and its 250V AC rating is suitable for typical UAE low-voltage installations when applied correctly. The complete circuit must comply with applicable UAE electrical regulations, project specifications and local authority requirements.

Single-pole switching means the socket switch disconnects the live conductor only. This provides convenient local control of the connected appliance, but it should not be treated as complete electrical isolation because the neutral and protective earth remain connected. The circuit must be isolated at the distribution board before maintenance.

The socket is rated at up to 13A and 250V AC. It is suitable for compatible appliances and equipment whose operating current, plug and circuit requirements remain within this rating. Actual circuit capacity also depends on cable size, protective-device rating, installation method, ambient temperature and other connected loads; high-demand equipment should be checked by a qualified electrician.

It can be used as a general-purpose indoor outlet in villas, apartments, offices, hotels, retail units and other commercial interiors. Typical applications include power for computers, televisions, chargers and suitable small appliances. It should not be installed in wet, exposed or outdoor locations unless the complete installation provides the required ingress protection and complies with the relevant location rules.

Installation should be completed by a qualified electrician. The circuit must first be safely isolated and verified dead. A compatible concealed wall box is installed square and flush with the finished surface, after which the live, neutral and protective-earth conductors are terminated at the correctly marked terminals. The socket is then secured without trapping cables, fitted with the matching frame, and electrically tested before energisation.

The product dimensions are approximately 35 x 86 x 86 mm. Select a compatible flush box that accommodates the device depth, cable bend radius, terminal space and required frame without compressing the conductors. For blockwork, concrete or drywall construction, coordinate the box position and depth before plastering, tiling or wall-panel installation.

The socket requires correctly identified live, neutral and protective-earth conductors from a suitable final circuit. Conductors must have the appropriate material, cross-section and insulation rating for the circuit design. Terminals should be tightened to the manufacturer's specified torque, with no exposed copper outside the terminal and with protective-earth continuity maintained.

It may be used where the project design permits a compatible 13A socket on a ring or radial final circuit. Suitability depends on the selected cable size, protective device, circuit loading, installation method and applicable UAE authority requirements. The circuit arrangement should be confirmed from approved drawings or by the project's electrical engineer.

Contractors should verify the approved material submittal, socket and plug format, rated current and voltage, circuit schedule, conductor size, earthing provision, protective-device coordination, mounting-box compatibility and final finish. Installation should also follow ABB instructions, project specifications and the requirements of the relevant UAE authority, such as DEWA, ADDED or the applicable local utility.

Use in kitchens, bathrooms, balconies or outdoor areas requires careful assessment of moisture, splash zones, ingress protection and local electrical rules. This product is described as a flush-mounted indoor socket and no specific IP rating is stated in the supplied data. For damp, wet or exposed locations, choose an appropriately IP-rated accessory and ensure suitable RCD protection where required.

No. Dune Sand refers to the decorative colour finish and does not change the socket's 13A, 250V AC electrical rating. To maintain a consistent appearance, use the compatible ABB Millenium frame and coordinate the accessory colour with adjacent switches, wall paint, tiles or interior panels.

Before handover, a qualified electrician should inspect terminal security and verify protective-conductor continuity, polarity, insulation resistance and the operation of the socket switch. Relevant circuit protection and RCD operation should also be tested where applicable. Results should be documented as required by the project specification and local inspection procedures.

Keep the faceplate clean with a soft, dry or lightly damp cloth and avoid abrasive cleaners or solvents. Periodically check for discoloration, heat damage, cracking, loose mounting or intermittent operation. If the socket becomes warm, produces arcing sounds or no longer holds a plug securely, stop using it and arrange inspection by a qualified electrician.