ABB Millenium 15A Double Pole Single Switched Socket Antique Gold AM20986-AG

Double-pole switching disconnects both the live and neutral conductors when the socket is switched off. This provides more complete local isolation than a single-pole design, subject to correct wiring and the requirements of the electrical installation.

It is intended for compatible equipment fitted with a matching 15A round-pin plug and operating within the socket's 15A, 250V AC rating. Typical applications may include designated appliances, lighting equipment or dedicated loads specified by the electrical consultant. The connected load, plug type, cable size and circuit protection must all be verified before use.

This model is a 15A round-pin socket and should not be assumed to accept the common rectangular-pin Type G plug used for many UAE appliances. Confirm the appliance plug configuration and project specification before ordering. Loose adapters or forced connections must not be used.

Its 250V AC rating is suitable for compatible circuits within the UAE's nominal low-voltage supply environment. However, product selection and installation must comply with the applicable UAE electrical regulations, local authority requirements and approved project drawings. A licensed electrician should confirm socket format, circuit rating, earthing and protective-device compatibility.

The socket is designed for flush mounting, with the wiring and mounting enclosure concealed behind the finished wall. Isolate and verify the supply is dead, install a compatible flush box, terminate the conductors in the marked terminals, secure the mechanism, align the matching frame and test the completed circuit. Installation should be performed by a qualified electrician.

A compatible flush-mounting box must provide the correct fixing arrangement and enough internal depth for the mechanism, cable bends and safe conductor termination. The product measures approximately 35 x 86 x 86 mm, but the required box depth should be checked against ABB installation information and actual site wiring conditions before wall preparation.

Cable size and protective-device rating cannot be selected from the socket rating alone. They depend on the connected load, circuit design, installation method, cable length, ambient temperature, grouping, voltage drop and fault protection requirements. In UAE construction projects, these details should be determined by the electrical engineer and installed according to the approved load schedule and local regulations.

Flush mounting conceals the fixed wiring and most of the accessory body inside the wall, creating a neat, low-profile finish. It is particularly useful in villas, apartments, hotels and offices where clean alignment with wall finishes is required. The mounting box should be positioned accurately before plastering, tiling or decorative cladding is completed.

Verify model number AM20986-AG, the 15A round-pin connector format, 250V AC rating, double-pole switching, 1-gang configuration, antique gold finish and flush-mounting requirements. Contractors should also confirm the required quantity, compatible frames and back boxes, approved material submittal, appliance plug type and the project's electrical specifications.

Switch off and isolate the circuit before inspection or cleaning. Wipe the visible surface with a soft, dry or slightly damp cloth, and avoid abrasive pads, solvents and harsh chemical cleaners that could damage the antique gold finish. Any overheating, discolouration, looseness, arcing or intermittent operation should be investigated immediately by a qualified electrician.

The electrician should inspect terminal tightness, conductor identification, earth continuity, polarity, insulation resistance, switch operation and the performance of the relevant protective device. The faceplate should be secure and level, and the outlet should be tested only with a compatible 15A round-pin plug and an approved load.

The supplied information identifies it as a flush-mounted socket but does not state an outdoor or weatherproof IP rating. It should therefore be treated as an indoor product unless ABB documentation confirms otherwise. Outdoor, bathroom, wash-area and other damp-location installations require appropriately rated accessories and compliance with applicable electrical-zone requirements.

Yes. The antique gold finish is well suited to villas, hotels, serviced apartments, executive offices and other premium UAE interiors where electrical accessories must coordinate with decorative metalwork, lighting controls and interior finishes. Confirm the finish against a physical sample when exact colour matching is important.

The ABB Millenium AM20986-AG is a 1-gang, flush-mounted 15A round-pin socket outlet with an integrated double-pole switch. It is rated for operation at up to 250V AC and features an antique gold finish for premium residential, hospitality and commercial interiors.