صمام زاوية قياس (1/2-3/8)

This valve acts as a quarter‑turn shutoff for a fixture's water supply. The lever handle turns 90 degrees to open or close the flow, providing a tight, leak‑proof seal when closed. It is designed for standard residential water supply lines.

Size: 1/2" inlet to 3/8" outlet. It features a lever handle for easy operation and is intended for potable water supply. The valve is described as durable and designed to provide long‑lasting performance with a leak‑proof seal when closed.

It is typically used to control water supply to fixtures such as sinks, toilets, appliances, and other standard residential connections that use a 1/2" x 3/8" valve configuration.

Here are comparable alternatives currently available on Fepy.com: - 1/2" x 3/8" Compression Angle Valve: https://fepy.com/products/12-x-38-compression-angle-valve - 1/2" x 3/8" Push‑Fit Angle Valve: https://fepy.com/products/12-x-38-push-fit-angle-valve - 1/2" x 3/8" Sweat/Angled Angle Valve: https://fepy.com/products/12-x-38-sweat-angle-valve

Typical use cases include supplying water to under‑sink fixtures, toilets, or appliances where a 1/2" x 3/8" valve connection is required. It’s a common choice for residential plumbing projects where a quick, reliable shutoff is needed.

Before installation, shut off the main water supply and drain the line. Verify the inlet and outlet match your supply lines. Connect the valve using the appropriate method for your setup (compression, push‑fit, or thread/sweat, as applicable), then hand‑tighten and snug with a wrench. Turn the water back on and inspect for leaks, tightening slightly if necessary.

Yes. The product is described as suitable for water supply applications, and it is intended for use with potable water in residential plumbing. Always ensure materials are compatible with your local codes and standards.

Regularly inspect connections for signs of moisture or corrosion, tighten fittings if a slow leak appears (do not overtighten), and replace any worn washers or seals as needed. If corrosion or damage is evident, replace the valve to maintain a tight seal.

Consider the type of connection you need (compression, push‑fit, or sweat) and ensure the inlet/outlet sizes match your existing supply lines. Compare the specific valve materials, ease of installation, and available options on Fepy.com to select the best fit for your project. See the comparison options listed by product page for guidance.

The listing describes the valve itself for a 1/2" x 3/8" configuration and its intended use. Depending on the source listing, fittings or hardware may vary, so check the specific product page for included components and ensure you have the correct connectors for your line.

If you’re comfortable with basic plumbing tasks and can safely shut off the water and drain the line, you can replace the valve. Ensure you select the correct size and connection type. If you’re unsure about any step, consult a licensed plumber.

The valve size 1/2" x 3/8" refers to the inlet and outlet fittings. Check the existing supply lines or the valve you’re replacing to match the 1/2" inlet to your supply and the 3/8" outlet to the fixture line. If in doubt, compare with compatible valves on Fepy.com and use the product specs to verify compatibility.