ABB Inora 1 Gang RJ45 Cat 6A Data Outlet Royal Gold BL318-PG

When installed as part of a fully compliant Category 6A channel, the socket is suitable for high-speed Ethernet applications, including data networks, IP telephony, smart-home systems, CCTV networks and compatible building-management devices. CAT.6a cabling can support data rates up to 10 Gigabit Ethernet over channel distances permitted by the applicable structured-cabling standard.

Yes. The ABB Inora 1 Gang CAT.6a Data Socket is suitable for structured network outlets in UAE villas, apartments, offices, hotels, retail spaces and other commercial developments. Its royal gold finish is particularly relevant for premium interiors, while its single-gang configuration provides a neat termination point for one network connection.

Use genuine Category 6A cable and compatible CAT.6a termination components. The cable construction, shielding arrangement and conductor type should match the socket mechanism and the project specification. To achieve CAT.6a performance, the complete permanent link—including cable, outlet, patch panel and patch cords—must be appropriately rated and correctly installed.

Installation should be carried out by a qualified ELV or structured-cabling technician. The cable is routed into the suitable wall box, prepared without excessive untwisting, terminated according to the socket instructions using one consistent T568A or T568B wiring scheme, and secured with the specified bend radius and strain relief. The socket is then fitted level into the compatible mounting box and tested before handover.

Either T568A or T568B may be used if supported by the termination module, but the same wiring scheme must be maintained at both ends of the cable and throughout the project. T568B is common in many commercial installations, although contractors should always follow the consultant's structured-cabling schedule, project drawings and local authority requirements.

CAT.6a data cables should be routed separately from mains power cables to reduce electromagnetic interference and support safe installation. Contractors should follow the required separation distances, containment rules, fire-stopping provisions and crossing methods stated in the project specifications and applicable UAE authority regulations. Where routes must cross, a perpendicular crossing is generally preferred.

No. Network performance depends on the entire installed channel, not only the wall socket. CAT.6a-rated cable, connectors, patch panels and patch leads must be used, and workmanship requirements such as pair-twist retention, cable bend radius, pulling tension and shielding continuity must be observed. The completed link should be certified with a calibrated network cable tester.

At minimum, installers should check wire-map accuracy, continuity, opens, shorts, split pairs and cable length. For projects requiring formal CAT.6a compliance, permanent-link certification should also assess parameters such as insertion loss, return loss, near-end crosstalk and related performance limits. Test reports are commonly included in UAE construction handover documentation.

This type of decorative data socket is generally intended for indoor use in dry locations unless the manufacturer's documentation confirms a specific ingress-protection rating. For outdoor areas, wash zones, plant rooms or humid environments, install it only within a suitably rated weatherproof enclosure and in accordance with the project's environmental and electrical requirements.

It may form part of a Power over Ethernet connection for compatible IP cameras, access points, VoIP phones and other network devices, provided the complete cabling channel, connector hardware and installation are rated for the intended PoE standard and power level. Correct termination, cable bundling, heat management and equipment compatibility should be verified by the installer.

Confirm the required quantity, one-gang outlet layout, royal gold finish, compatible mounting box and frame arrangement, cable category, shielding requirements, termination type and approved wiring standard. Contractors should also compare model number BL318-PG with the consultant's material submittal, room finish schedule and approved ABB Inora accessory range before procurement.