ABB Inora 1 Gang 45-Degree Satellite F-Type Outlet Starry Black BL308-885

This socket is used as the finished wall outlet for a satellite television distribution system. It can connect a compatible coaxial cable installed inside the wall to a satellite receiver, set-top box or television system. It is suitable for apartments, villas, hotels, offices and other UAE projects with centralized or individual satellite services.

One gang means the accessory provides one satellite connection position within its compatible mounting arrangement. It is intended for locations that require a single dedicated SAT outlet rather than multiple television, radio or data connections.

The angled connection helps guide the coaxial lead away from the wall more naturally than a straight-facing outlet. This can reduce sharp cable bends, improve access behind furniture or wall-mounted equipment and support a neater final installation. Adequate clearance should still be maintained to avoid compressing or kinking the coaxial cable.

Yes, it is relevant to UAE villas, apartments, hotels and commercial fit-outs that require a dedicated satellite TV outlet. Before specification, the consultant or contractor should confirm compatibility with the project's approved faceplate system, back box, coaxial network and local authority or developer requirements.

Installation normally involves isolating nearby electrical circuits, preparing the compatible wall box and support frame, terminating the designated coaxial cable correctly, securing the SAT module and fitting the matching ABB Inora cover or faceplate. The cable screen and centre conductor must be prepared without shorts, loose strands or excessive exposed conductor. Installation and testing should be completed by a qualified ELV or electrical technician in accordance with the approved project drawings and manufacturer instructions.

Back-box compatibility should be verified before installation because mounting dimensions, support frames and faceplates can vary between wiring-accessory ranges. For a consistent fit and finish, use the compatible ABB Inora mounting components specified for model BL308-885 and check that the box depth allows the coaxial cable to maintain its recommended bend radius.

Use a project-approved 75-ohm coaxial cable intended for satellite-frequency distribution, typically a properly screened cable selected by the system designer. Cable grade, shielding performance, fire classification and routing method should match the building specification and applicable UAE project requirements. Avoid tight bends, crushed sections and close parallel runs with power cables where segregation is required.

The wall outlet itself is a passive connection accessory and does not normally require a separate mains power supply. However, some satellite systems pass low-voltage DC power and control signals through the coaxial cable to equipment such as an LNB or multiswitch. The complete system design and equipment compatibility should therefore be checked before commissioning.

It is identified as a SAT socket and should primarily be specified for compatible satellite distribution systems. Do not assume it is suitable for terrestrial TV, FM radio or cable television without confirming the connector type, frequency range and system design in ABB's current technical documentation.

Inspect the termination for secure contact, correct screening and absence of a short circuit between the centre conductor and shield. The outlet should then be tested using suitable coaxial or satellite signal equipment to verify continuity, signal level and signal quality. In multi-outlet projects, label and test each point against the approved ELV drawings before handover.

It is best suited to dry indoor locations unless the completed assembly has a specifically declared outdoor or ingress-protection rating. For balconies, terraces, service areas or other locations exposed to humidity, dust or water, use a suitable weatherproof enclosure or an accessory rated for those conditions and follow UAE project requirements.

Confirm the model number BL308-885, Starry Black finish, single-gang SAT configuration, connector compatibility, required mounting frame, matching faceplate and back-box dimensions. Contractors should also verify the quantity against the latest drawings and ensure that the outlet matches the project's satellite headend, multiswitch and coaxial cabling design.

Keep the surface clean with a soft, dry or lightly damp cloth and avoid abrasive pads, solvents and aggressive chemicals that could damage the finish. Check periodically for a loose connector, damaged coaxial lead or unstable signal. Any internal inspection or retermination should be performed by a competent technician.