ABB Inora 2 Gang 13A Double Pole Switched Socket Outlet with Dual USB Type-A Ports Royal Gold BL262-PG

Yes, this 13A socket format is suitable for projects using the British-style socket system widely adopted across the UAE. Selection and installation should comply with the applicable requirements of BS 1363, BS 7671 and the regulations of the relevant UAE authority, such as DEWA, ADDC or the local electricity provider. The project consultant or licensed electrical contractor should verify final compliance.

It can be used with compatible 13A plug-equipped appliances such as televisions, computers, lamps, chargers and common household or office equipment. The connected load must remain within the socket rating and the capacity of the circuit. High-load appliances should only be connected after an electrician confirms the circuit design, cable size and protective-device rating.

The integrated USB function allows compatible devices to be charged without occupying a mains outlet or requiring a separate plug-in adapter. This is useful beside beds, desks, workstations and living-room furniture. Check the product packaging or official ABB technical data for the USB connector type, voltage, current and charging-protocol compatibility before specifying it for a project.

The BL262-PG is described as a double switched socket, providing local switching for improved control and convenience. Installers should confirm the switch arrangement and terminal layout from the wiring diagram supplied with the product before installation.

Installation should be completed by a licensed electrician. The supply must be isolated and proven dead before the conductors are connected to the marked live, neutral and earth terminals in accordance with the ABB wiring diagram. The mechanism should then be secured to a compatible wall box, aligned correctly and tested for polarity, earth continuity, insulation resistance and functional operation before energisation.

A compatible two-gang wall box with sufficient internal depth is required. Because the product includes USB charging electronics, it may need more rear clearance than a standard socket. Confirm the mounting dimensions and minimum box depth from the ABB datasheet, and allow extra space for safe conductor bends without compressing cables or terminals.

Yes, it can be specified for new villas, apartments, hotels, offices and commercial fit-outs, as well as renovation projects. During replacement work, the contractor should check the existing back box, cable condition, earthing, circuit protection and available installation depth rather than assuming direct compatibility with the old accessory.

The Royal Gold finish is well suited to premium residential and hospitality interiors, including bedrooms, living rooms, executive offices, hotel suites and reception areas. It can complement gold-toned hardware, decorative lighting and luxury wall finishes while providing practical power and USB charging access.

This type of decorative indoor socket should only be installed where the location and required ingress protection are appropriate. In kitchens, maintain the clearances required by the project specification and local electrical rules. Bathrooms, wash areas, balconies and outdoor locations may require dedicated weatherproof or suitably IP-rated accessories, so approval from the electrical consultant is recommended.

The final circuit should use correctly sized conductors and suitable overcurrent and residual-current protection as required by the approved electrical design, BS 7671 and the relevant UAE authority. Protective-device ratings must be based on the circuit arrangement, cable capacity, installation method and expected load rather than on the socket rating alone.

They may generally be used together provided the mains loads remain within the permitted circuit capacity and the USB-connected equipment is compatible with the charger's specified output. Avoid overloading the socket through unsuitable multi-plug adapters or extension devices, and verify the exact USB output in the official ABB documentation.

The electrician should confirm secure terminations, correct polarity, effective earthing, suitable insulation resistance and proper operation of both switches, outlets and USB charging function. Any testing must follow the approved project method statement and applicable electrical regulations. The faceplate should sit evenly against the finished wall without trapped conductors or visible damage.

Isolate the electrical supply before maintenance and clean the faceplate with a soft, dry or lightly damp cloth. Do not use abrasive pads, solvents, acidic cleaners or excessive water, as these may damage the decorative finish or enter the electrical mechanism. A qualified electrician should inspect the unit if it becomes loose, discoloured, unusually warm or intermittent.