ABB Inora 1 Gang 13A Double Pole Switched Socket Outlet with Illumination Starry Black BL238-885

Double-pole, or DP, switching disconnects both the live and neutral conductors when the socket is switched off. This provides more complete isolation than single-pole switching and is useful for fixed-use appliance points and installations where enhanced electrical isolation is specified.

The neon indicator provides a visible indication of the socket's switched status. It helps users quickly identify whether the outlet is energised, which is useful in kitchens, utility rooms, offices, plant support areas and other locations where connected equipment must be monitored.

The socket's 13A format is commonly used in UAE buildings that use British-style plug systems. UAE low-voltage supplies are generally 230V at 50Hz, but the installer must verify the product's marked voltage, applicable certification and compatibility with the project's approved electrical specifications before installation.

It can be used with compatible 13A plug-top appliances whose operating current does not exceed the socket, circuit and protective-device ratings. Typical applications include computers, televisions, small kitchen appliances, chargers and office equipment. High-load equipment, motors and heating appliances must be checked for running current, starting current and manufacturer requirements.

The connected load must not exceed 13A. On a nominal 230V supply, 13A corresponds to approximately 2,990W, but this is only a general electrical calculation. Actual suitability depends on the appliance load, duty cycle, circuit design, cable size, protective device and installation conditions. Continuous or high-inrush loads should be assessed by a qualified electrician.

Installation should be completed with the circuit isolated, locked out where required and tested to confirm it is dead. A qualified electrician should connect the live, neutral and earth conductors to the correctly marked terminals, secure the socket to a compatible wall box, check terminal tightness and perform continuity, polarity, insulation-resistance and functional tests before energising the circuit.

It may replace a compatible single socket if the wall box dimensions, mounting centres, wiring capacity, conductor condition and circuit arrangement are suitable. Because plate and back-box requirements can vary, installers should compare the existing box with the ABB Inora product dimensions and installation instructions before ordering or fitting.

Yes. A protective earth conductor should be connected to the designated earth terminal in accordance with the approved wiring design and local electrical requirements. Earth continuity must be verified after installation, particularly where metal back boxes or other conductive components are used.

Yes, it is well suited to residential, hospitality, commercial and office fit-outs where black wiring accessories complement dark walls, stone finishes, cabinetry or contemporary interiors. For construction projects, consultants and contractors should confirm the model, finish, mounting arrangement, electrical rating and compliance documents against the approved material submittal and project specification.

It can be considered for indoor kitchens and utility spaces when positioned in accordance with applicable electrical-zone, clearance and circuit-protection requirements. It should not be installed where it may be exposed to water, heavy condensation or washdown conditions unless ABB specifically confirms a suitable IP rating or an appropriate weatherproof enclosure is provided.

Do not assume that this decorative indoor socket is weatherproof. Outdoor UAE conditions can include rain, dust, humidity, high temperatures and strong UV exposure. Outdoor installations should use a socket or enclosure with an appropriate verified IP rating and material specification for the location, installed according to local authority and project requirements.

Protection must follow the approved electrical design and applicable local authority requirements. Depending on the circuit and location, this may include a correctly rated MCB or RCBO, suitable cable sizing, effective earthing and residual-current protection. The electrician must coordinate the socket with the distribution board, fault level, circuit type and connected load.

Switch off the circuit before cleaning and use a soft, dry or slightly damp cloth. Do not use abrasive pads, solvents, strong chemicals or excessive water, as these may damage the Starry Black finish or enter the electrical mechanism. Periodic inspection should check for heat marks, cracking, loose mounting, buzzing or plug-contact damage.

The handover inspection should confirm the correct ABB model BL238-885 and Starry Black finish, secure alignment, smooth switch operation, neon functionality, correct polarity, earth continuity and satisfactory electrical test results. Any required test certificates, product approvals, as-built circuit references and operation and maintenance documentation should also be included.