ABB Inora 2 Gang 1 Way 20AX Switch Classic Grey BL114-G

The term 2 gang means the switch has two separate controls on one faceplate. A 1-way switch controls each connected circuit from a single switching point and is not intended for standard two-location switching. The 20AX marking indicates a switch rating designed to handle demanding AC lighting loads, including loads that may produce higher starting or inrush current, subject to ABB specifications and the connected load type.

This switch is suitable for indoor lighting control in villas, apartments, offices, retail units, hotels and other building projects. Typical applications include controlling two separate lighting zones, such as ceiling lights and wall lights, from one position. Compatibility with fans, contactors or other loads should be confirmed from the equipment ratings and the approved electrical design.

Yes. Each rocker can operate a separate 1-way circuit, enabling two lights or lighting groups to be switched independently from the same wall position. Each circuit must be correctly wired, remain within the permitted electrical rating and use compatible conductors and protective devices.

No, not in a conventional two-way switching arrangement because BL114-G is specified as a 1-way switch. Controlling the same light from two locations, such as at both ends of a corridor or staircase, normally requires suitable 2-way switches and the correct interconnecting wiring.

Installation should begin by isolating and verifying the electrical supply as de-energised. A qualified electrician should identify the incoming live conductor and the two switched-live conductors, terminate them at the appropriate marked terminals, tighten connections to the manufacturer's specified torque, fit the mechanism into a compatible wall box and attach the faceplate securely. The circuit should then be tested for polarity, insulation integrity and correct operation before handover.

A conventional mechanical 1-way switch generally interrupts the live conductor and does not normally require a neutral connection at the switch mechanism. However, the actual wiring arrangement must follow the terminal markings, ABB instructions and the project's approved electrical drawings. A neutral may still be present in the wall box for other equipment or future requirements.

The contractor should verify the supply characteristics, circuit load, conductor size, protective device, wall-box compatibility, terminal identification and intended switching arrangement. Installation must follow the latest applicable UAE electrical regulations, local authority requirements and project specifications. Requirements may differ by emirate and utility authority, so approval documents and consultant instructions should be checked before installation.

It may be used with compatible LED lighting circuits, but the total wattage alone is not enough to determine suitability. LED drivers can create substantial inrush current, so installers should check the driver's switching-current data, the number of fittings per circuit and ABB's load guidance. For large lighting banks, a correctly rated contactor or control device may be required.

Yes. The neutral Classic Grey finish coordinates well with concrete-inspired, industrial, contemporary and darker interior schemes commonly used in UAE villas, apartments, offices, shops and hospitality projects. Designers should confirm that the finish and Inora accessory range match the project's approved material schedule.

It should not be assumed to be weatherproof or suitable for exposed outdoor locations unless the complete installation has the required ingress-protection rating. Outdoor areas, bathrooms, washrooms and other damp locations may require an appropriately rated enclosure, suitable accessories and installation within permitted electrical zones. Always follow local regulations and project requirements.

Use a wall box and mounting accessories compatible with the ABB Inora range and the switch's mounting format. The box should provide adequate depth for conductor bending, safe terminal clearance and secure alignment. Before bulk procurement, contractors should verify box dimensions, fixing centres, plate compatibility and coordination with the selected conduit or cable-management system.

Isolate the circuit before inspection or maintenance. Clean the faceplate with a soft, dry or slightly damp cloth and avoid abrasives, solvents and aggressive chemicals that could damage the finish. Loose operation, unusual heat, buzzing, discoloration or intermittent switching should be investigated promptly by a qualified electrician rather than repaired while energised.

The BL114-G combines two independent controls in one wall position, helping simplify layouts and maintain a coordinated accessory appearance. Its 20AX classification is relevant to many modern lighting applications, while the Classic Grey finish supports contemporary specifications. Final selection should be based on the approved load schedule, wiring design, installation environment and compatibility with the complete ABB Inora system.