ABB Inora 2 Gang RJ11 Telephone Outlet Royal Gold BL322-PG

The two-gang configuration provides two RJ11 connection outlets on a single wall plate. Subject to the project’s cabling design, the outlets can be terminated for separate telephone lines or other compatible low-voltage services. Each outlet must be wired and labelled according to the approved telecom layout.

This socket is suitable for villas, apartments, offices, hotels, receptions, meeting rooms and other indoor locations that require fixed telephone or compatible RJ11 connectivity. Its royal gold appearance makes it particularly relevant to decorative interiors where wiring accessories must coordinate with premium finishes.

Yes, it is relevant to UAE residential and commercial fit-out projects that use RJ11 telephone infrastructure. Before procurement, the consultant or contractor should confirm that the ABB Inora range, connector type, mounting arrangement and finish comply with the approved material schedule, telecom drawings and requirements of the relevant UAE authority or service provider.

Installation typically involves isolating the work area, preparing a compatible concealed or surface-mounted box, terminating the low-voltage telephone conductors on the designated contacts, securing the mechanism and fitting the faceplate. The installer should follow the ABB product instructions and approved project drawings, maintain correct conductor pairing and test both outlets after installation.

Yes. Installation should be completed by a qualified electrician or ELV and telecommunications technician. Correct termination is important for reliable signal quality, while proper segregation from mains wiring is required to reduce interference and support compliance with UAE project specifications and accepted electrical installation practices.

Telephone and other extra-low-voltage cables should generally be segregated from mains power wiring unless an approved partitioned containment system and the applicable project standards permit otherwise. Separate conduit, trunking compartments and suitable back boxes help reduce electrical interference and improve installation safety. Contractors should follow the consultant-approved drawings and relevant UAE regulations.

It is intended for compatible RJ11 plugs and correctly terminated telephone cabling. Compatibility should be checked against the handset, PABX or PBX system, service-provider equipment and cable pinout because telephone systems can use different conductor assignments. It should not be assumed to support larger RJ45 Ethernet plugs.

No, an RJ11 telephone socket is not a substitute for an RJ45 network outlet. Ethernet installations normally require RJ45 modules and appropriately rated structured cabling such as Cat6 or another category specified by the network design. Use the BL322-PG only for services confirmed as compatible with RJ11 connectivity.

They can be configured for two independent lines if each outlet is connected to a separate line and the building’s telecom or PABX system supports that arrangement. Alternatively, the design may distribute the same service to both outlets. The final configuration depends on the approved wiring schematic and must be verified through testing and labelling.

Confirm the model number BL322-PG, two-gang RJ11 requirement, royal gold finish, compatible ABB Inora mounting components, back-box dimensions, cable termination method and approved project schedule. It is also advisable to verify required quantities, spare allowances and coordination with adjacent switches and sockets to maintain a consistent finish.

Disconnect or protect connected telecom equipment before maintenance, then clean the faceplate with a soft, dry or slightly damp cloth. Do not use abrasive pads, solvents or aggressive chemicals, as they may affect the royal gold finish. Inspect the ports periodically for dust, loose plugs or physical damage, especially in hotels and frequently used commercial spaces.

This decorative telephone socket is generally intended for dry indoor locations. Do not install it in exposed outdoor areas, bathrooms or other damp and dusty environments unless the completed assembly has a confirmed ingress-protection rating suitable for that location. UAE projects should follow the environmental and IP requirements stated in the electrical and ELV specifications.

After termination, the technician should inspect conductor placement, verify continuity and polarity or pin assignment as required by the telephone system, check for shorts and confirm service at both outlets using suitable test equipment or a compatible handset. Each port should then be labelled in accordance with the project’s telecom numbering schedule.