ABB Inora 2 Gang TV and RJ11 Telephone Outlet Classic Grey BL324-G

The television connection supports frequencies from 5 MHz to 1000 MHz. This range is commonly used for terrestrial television, cable TV and compatible RF distribution systems. Signal compatibility should be confirmed against the building's antenna, MATV, SMATV or cable network design before installation.

This outlet is suitable for apartments, villas, offices, hotels, staff accommodation and other buildings requiring TV and telephone connections at a single wall location. Typical installation points include living rooms, bedrooms, hotel guest rooms, reception areas, meeting rooms and office workspaces.

Yes, it is relevant to UAE residential and commercial projects where combined low-voltage TV and telephone outlets are specified. The final installation must follow the approved project drawings, local authority requirements, the telecommunications provider's specifications and applicable UAE fire and low-voltage cabling requirements.

Installation should be carried out with the relevant circuits and services isolated. Mount the outlet in a compatible wall box, prepare the coaxial and telephone cables without damaging their conductors, terminate each cable at its designated connector, secure the mechanism and align the faceplate. Test both services before handover. A qualified ELV or telecommunications technician is recommended.

The TV side normally connects to a 75-ohm coaxial cable used by the building's television distribution system. The telephone side connects to the approved telecom cable specified for the project. Exact cable type, connector format, pin arrangement and termination method should be verified against the outlet instructions and the project's ELV schedule.

It may support services delivered over a compatible telephone line, such as certain voice or DSL connections, but it should not be assumed to replace an RJ45 data outlet. For structured Ethernet networks, Wi-Fi access points or high-speed LAN connections, use the data outlet and Category cable specified by the project's ICT consultant or service provider.

It can be positioned within a coordinated accessory layout, but TV and telephone cables are extra-low-voltage services and must be segregated from mains wiring as required by applicable regulations and project specifications. Use suitable partitioned boxes, containment and cable routing to reduce electrical interference and maintain safe separation.

Use correctly rated 75-ohm coaxial cable, avoid sharp bends and cable crushing, keep the shielding intact and make clean, secure terminations. The distribution network should also have suitable splitters, amplifiers and termination points. After installation, test signal level and quality with an appropriate RF meter rather than relying only on a visual television check.

The outlet is intended for a finished wall-accessory arrangement and may be used in concealed installations when paired with the correct compatible back box and mounting components. Before closing gypsum board, blockwork chases or wall finishes, confirm box depth, cable entry, bend radius and faceplate alignment.

Confirm the model number BL324-G, Classic Grey finish, required TV frequency range of 5–1000 MHz, connector compatibility, back-box dimensions and compatibility with other ABB Inora accessories used on the project. Buyers should also check the approved material submittal, room data sheet and ELV outlet schedule.

Yes, the combined format is useful in hotels, apartment towers and staff housing because it places TV and telephone services in one coordinated outlet location. For large projects, consultants should verify compatibility with the central MATV or SMATV system, PABX or telecom network, room layouts and approved interior finish schedule.

Keep the faceplate clean with a soft, dry or slightly damp cloth and avoid abrasive cleaners or solvents. If TV reception or telephone service becomes unreliable, inspect the patch leads first and then have a qualified technician check the concealed cable, terminations and upstream distribution equipment. Do not insert unsuitable plugs or tools into either connection.