ABB Inora 2 Gang TV and RJ11 Telephone Outlet Starry Black BL324-885

The 5-1000 MHz specification refers to the operating frequency range of the TV signal path. This range is commonly used for terrestrial television, cable TV and selected RF distribution systems. Actual reception quality will also depend on the coaxial cable grade, signal source, splitters, amplifiers, connector quality and correct termination throughout the installation.

This outlet is suitable for indoor communication points in villas, apartments, offices, hotels, reception areas and other commercial interiors. It can be installed behind televisions, in living rooms, bedrooms, meeting rooms or hospitality spaces where both TV and telephone services are required at the same location.

Yes, it is relevant to UAE residential and commercial fit-outs where coordinated TV and telephone outlets are included in the ELV layout. Before specification, the consultant or contractor should confirm compatibility with the project's approved faceplate range, back box, cabling system, telecom provider requirements and applicable local authority or developer standards.

The outlet should be fitted to a compatible flush or surface-mounted back box and connected to the designated TV coaxial and telephone cables. Route and terminate each cable according to the terminal markings and project drawings, secure the outlet without overtightening, fit the front plate and test both services. Installation should be completed by a qualified electrician or ELV technician.

The TV connection normally requires project-approved 75-ohm coaxial cable, while the telephone connection requires the appropriate telecom cable specified for the system. Cable category, conductor arrangement and termination method should be checked against the outlet terminals, telecom equipment and UAE project specifications before installation.

TV and telephone circuits are extra-low-voltage services and should be segregated from mains power wiring in accordance with the approved electrical and ELV design. Where services are installed nearby, use suitable compartmented boxes, conduits or trunking and maintain the required separation to reduce electrical interference and support safe installation.

It can be used for renovation or replacement when the existing back box, mounting arrangement, cable terminations and associated ABB Inora components are compatible. Contractors should verify dimensions and wiring before removing the old outlet, as accessories from different ranges or manufacturers may not use interchangeable plates, supports or mounting hardware.

The listed operating range is 5-1000 MHz. Many satellite intermediate-frequency systems operate above 1000 MHz, so this model should not be assumed suitable for a satellite feed unless the system designer confirms compatibility. For satellite installations, select an outlet specifically rated for the full frequency range and required signal-passing features.

Use correctly specified 75-ohm coaxial cable, avoid sharp bends or crushed cable, prepare the conductor and shielding carefully, and make secure terminations without loose braid strands. Splitters and amplifiers should match the system design. After installation, test the outlet for signal level, continuity and picture quality using appropriate RF test equipment.

Check conductor continuity, polarity or pin allocation where required, terminal security and line performance using suitable telecom test equipment. Confirm that the outlet matches the project's analogue telephone, PBX or structured cabling arrangement. A physical telephone-style connection does not automatically confirm compatibility with every voice or data network.

It should not be treated as an Ethernet data outlet unless its connector and technical documentation specifically confirm the required data category. Telephone and Ethernet systems can use different wiring arrangements and performance standards. For network access, use a category-rated RJ45 data module that matches the installed structured cabling.

The Starry Black finish suits contemporary villas, apartments, offices, hotels and retail interiors, particularly when coordinated with dark switches, sockets and decorative wall finishes. Designers should confirm the finish against physical samples and specify matching ABB Inora accessories to maintain a consistent appearance across the project.

This product should be treated as an indoor accessory unless ABB documentation confirms a suitable ingress-protection rating and approved outdoor enclosure. For balconies, gardens, external majlis areas or other locations exposed to dust, humidity or water, use weatherproof accessories with an IP rating appropriate to the UAE environment.

Verify the model number BL324-885, Starry Black finish, two-gang configuration, 5-1000 MHz TV requirement, telephone connector compatibility, mounting system and back-box arrangement. Also check the approved material submittal, ELV drawings, quantities, cable specifications and coordination with the selected ABB Inora accessory range.