ABB Inora 4 Gang 1 Way 10AX Switch Royal Gold BL104-PG

Four gang means the switch has four individual rockers for four separate circuits. One way means each circuit is controlled from this single switch position rather than from two different locations. The 10AX rating indicates suitability for switching lighting loads, including loads with higher starting currents, subject to the connected lamp, LED driver and circuit design.

Yes. The four rockers can independently operate four separate lighting circuits, such as a chandelier, downlights, wall lights and decorative lighting. The circuits must be correctly wired and remain within the switch rating and the load limits specified by ABB and the lighting-equipment manufacturers.

It can be used with compatible LED lighting circuits, but the LED drivers' inrush current must be considered. The total wattage alone does not always determine compatibility because some drivers draw a high current when switched on. For projects with many LED fittings on one rocker, a qualified electrician should verify the load or use a suitable contactor or relay.

Not by itself. A one-way switch is intended to control a circuit from one location. Staircases, corridors and rooms requiring control from two positions normally need two-way switches and appropriate wiring. Confirm the required switching arrangement before ordering for a UAE construction project.

Installation should be completed by a qualified electrician. The supply must be isolated and verified dead before work begins. The electrician should confirm the wall box and wiring compatibility, connect the incoming live conductor and four switched-live outputs according to the ABB terminal markings, secure the switch without trapping conductors, fit the front plate and test every circuit. Neutral and protective-earth conductors must be terminated as required by the circuit design and applicable regulations.

Use a flush or surface mounting box that matches the switch dimensions, fixing centres and required wiring depth. Allow enough space for four outgoing conductors and any loop connections without sharply bending or compressing cables. Because box formats can vary between UAE projects, verify the ABB product drawing and the installed box before procurement or installation.

The 10AX wall-switch format is commonly used in UAE residential and commercial lighting installations. Suitability must still be confirmed against the project's nominal supply, typically 230 V at 50 Hz, the approved electrical design and the requirements of the relevant authority, such as DEWA, ADDC or the applicable local utility. Installation should follow current UAE regulations and recognised wiring practices such as BS 7671 where specified.

It is suitable for locations where several lighting zones need to be grouped at one point, including villa living rooms, hotel suites, apartment entrances, offices, majlis areas and premium retail interiors. Its four-gang layout can reduce the number of separate switch plates required while helping contractors maintain a coordinated decorative finish.

Do not assume that this decorative indoor switch is weatherproof. For outdoor, wet or dusty locations, use an enclosure or wiring accessory with an IP rating appropriate to the installation zone and environmental exposure. Bathroom positioning must also comply with applicable electrical zones, local regulations and the project consultant's specifications.

The BL104-PG is primarily intended for lighting-control applications. It should not be used as a socket outlet switch, isolator or direct controller for heavy motors and high-load equipment unless ABB documentation specifically permits the load. Fans, pumps and other inductive equipment may require a correctly rated isolator, relay or contactor selected by an electrical engineer.

A conventional mechanical one-way switch generally interrupts the live conductor and may not require a neutral connection at the switch mechanism. However, neutral and earth arrangements depend on the circuit design, local wiring method and terminal configuration. Follow the markings supplied with model BL104-PG and never connect conductors based only on colour assumptions.

Switch off the circuit before cleaning and wipe the surface with a soft, dry or slightly damp cloth. Do not use abrasive pads, solvents, acidic cleaners or strong construction chemicals, as these may damage the decorative finish. During painting, plastering and fit-out work, protect the switch from dust, moisture and impact, and remove protective covering only after nearby work is complete.

Confirm the model number BL104-PG, four-gang one-way configuration, 10AX rating, royal gold finish, required quantities, mounting-box compatibility and connected lighting loads. Contractors should also coordinate the finish with other ABB Inora accessories, review approved material schedules and samples, and verify consultant or authority requirements before bulk procurement.