ABB Inora 2 Gang 45A Double Pole Cooker Control Unit with 13A Switched Socket and Illumination Royal Gold BL118-PG

The 45A rating refers to the cooker control switch, while the 13A rating applies to the integrated socket outlet. These are separate functions within the accessory. The final circuit rating, cable size and protective device must be selected according to the connected cooker load, installation method, cable length, ambient temperature and applicable UAE electrical regulations.

Yes, it is suitable for appropriately designed UAE residential and commercial kitchen installations. UAE properties commonly use a nominal 230V, 50Hz single-phase supply for domestic circuits. Compatibility must still be confirmed against the cooker manufacturer's requirements and the regulations of the relevant local authority, such as DEWA, ADDC or the applicable emirate-level utility.

It may be used as a local isolation and control point for an electric oven, hob or freestanding cooker when the appliance load and circuit design are within the unit's 45A rating. The appliance nameplate, diversity calculations and manufacturer instructions should be reviewed by a qualified electrician before installation. Appliances exceeding the permitted circuit capacity require a separately engineered solution.

The 13A socket is intended for compatible plug-in appliances that do not exceed the socket's rated capacity, such as selected kitchen appliances. It should not be used for equipment with an unsuitable plug, excessive load or damaged cable. Avoid relying on extension leads or multiway adaptors around cooking areas, and keep connected equipment away from heat and water.

Installation should be completed by a licensed electrician with the supply isolated and verified dead. The installer must use a compatible wall box, terminate the incoming supply and cooker conductors at the correctly marked terminals, connect protective earth conductors, tighten terminals to the manufacturer's specified torque and test polarity, insulation resistance, earth continuity and operation before energising the circuit.

Cable size and protective-device rating cannot be selected from the switch rating alone. They depend on the cooker's connected load, installation method, conductor material, cable length, grouping, voltage drop and the high ambient temperatures encountered in the UAE. A qualified electrical engineer or electrician should calculate the circuit and coordinate the MCB or RCBO with the cable and appliance requirements.

The control unit should be readily accessible and normally positioned so the cooker can be isolated without reaching over a hot appliance. It must be kept away from direct heat, steam, splashing water and locations where cabinet doors obstruct access. Exact mounting height and separation should follow the kitchen layout, project drawings, appliance instructions and applicable UAE electrical and building requirements.

The Royal Gold finish is well suited to premium villas, apartments, hotel-style kitchens and coordinated interior fit-outs where electrical accessories form part of the visible design. Contractors should confirm the finish against approved material samples and coordinate it with handles, taps, lighting controls and other wiring accessories before bulk installation.

It should not be assumed suitable for outdoor, exposed or wet-area installation unless the complete assembly has an appropriate verified ingress-protection rating and enclosure. For outdoor kitchens or locations exposed to moisture, dust or weather, the consultant should specify a suitably rated weatherproof enclosure and accessories for the environmental conditions.

Before handover, the contractor should check terminal tightness, conductor identification, protective-earth continuity, polarity, insulation resistance, protective-device operation and functional switching. The accessory should be secure, level, undamaged and free from construction debris. Test results and circuit identification should be recorded in accordance with the project's inspection and commissioning requirements.

No. The 45A marking is the maximum rating of the cooker control switch under its specified conditions; it does not automatically confirm suitability for every appliance or circuit. The cooker's rated power and current, supply type, diversity allowance, cable capacity and protective device must all be checked before connection.

Isolate the circuit before inspection or cleaning. Wipe the faceplate gently with a soft, dry or lightly damp cloth, and do not use abrasive pads, solvent-based cleaners or excessive water that could damage the finish or enter the accessory. Arrange an electrician's inspection if there is discoloration, heat damage, buzzing, a loose plate, stiff switching or a burning smell.

Check the model number BL118-PG, 45A cooker-switch rating, 13A socket requirement, Royal Gold finish, mounting-box compatibility and the approved electrical schedule. For consultant-led UAE projects, contractors should also compare the manufacturer's current datasheet and certification information with the project's specified standards and local authority requirements before procurement.