ABB Millenium 13A Double Pole Double Switched Socket Dune Sand AM239147-DU

This ABB Millenium socket has a rated current of 13A and a rated voltage of 250V AC. It is a 2-gang, dual BS 13A socket outlet with double-pole switching and a flush-mounted installation format. Its listed dimensions are approximately 42 x 147 x 86 mm, and the product is supplied in a Dune Sand finish.

Double-pole switching means the socket switch disconnects both the live and neutral conductors simultaneously. This provides more complete local isolation than single-pole switching when the socket is switched off. The protective earth connection remains continuous and must never be switched or omitted.

Yes, its 250V AC rating and BS-type 13A outlet configuration are suited to the supply and plug format commonly used in UAE buildings. Final selection and installation must comply with the applicable UAE electrical regulations, the requirements of the relevant local authority, project specifications and ABB instructions. A qualified electrician should verify circuit protection, conductor size, earthing and mounting-box compatibility.

It is intended for indoor fixed-wiring applications such as villas, apartments, offices, hotels, retail units and other commercial developments. It can supply compatible appliances and equipment provided the connected demand remains within the socket and circuit ratings. It should not be installed outdoors, in wet areas or in exposed dusty locations unless a suitably rated protective enclosure and compliant installation method are specified.

Isolate and lock off the electrical supply, confirm the circuit is de-energised with approved test equipment, and install a compatible flush mounting box at the required depth and alignment. Terminate live, neutral and protective earth conductors at the correctly marked terminals, tighten them to ABB's specified torque, secure the socket without trapping cables, fit the matching frame and restore power only after inspection and testing. Installation should be completed by a licensed or suitably qualified electrician.

Contractors should confirm the approved ABB Millenium range, model AM239147-DU, Dune Sand colour, 2-gang layout, compatible frame and required flush box. They should also check wall-box dimensions, installation depth, cable capacity, circuit rating and the project's wiring-accessory schedule. For large UAE projects, retain product approvals, technical submittals and finish samples before procurement.

Both outlets can be used simultaneously, but the total connected load must remain within the limits of the socket assembly, branch circuit, cable and protective device. Do not assume that each outlet can continuously carry its full marked current at the same time without checking ABB documentation and the circuit design. High-load appliances should be assessed by the project electrician.

The electrician should inspect terminal tightness and conductor identification, then perform the tests required by the applicable project and local authority rules. These commonly include protective-conductor continuity, insulation resistance, polarity, earth-fault protection and functional operation of both switches and outlets. Test results should be recorded as part of the electrical installation documentation.

No. Dune Sand identifies the visible decorative colour and does not change the stated 13A, 250V AC electrical rating. To achieve a consistent finish, use the compatible ABB Millenium frame and matching accessories from the same colour range, and protect the surface from paint, plaster, abrasive cleaners and construction debris.

It can be used in renovation or replacement projects when the existing flush box, wiring arrangement, circuit protection and accessory dimensions are compatible. Do not rely on appearance alone: isolate the circuit, inspect cable condition and earthing, and confirm the box depth and fixing centres before installation. Damaged conductors, shallow boxes or incompatible frames should be corrected rather than forced into place.

Keep the faceplate clean with a soft, dry or lightly damp cloth and avoid solvents or abrasive products. Periodically check for heat discoloration, cracking, loose mounting, buzzing, sparking or switches that do not operate correctly. If any defect is found, stop using the outlet and have the circuit isolated and inspected by a qualified electrician; internal terminals must not be accessed while energised.