ABB Millenium 13A Single Pole Switched Socket with LED Matt Gold AM23486-MG

The socket is rated at 13A and 250V AC and uses a BS-style 13A socket outlet configuration. It features single-pole switching, an LED status indicator, secure cable terminals and flush mounting. Its stated dimensions are approximately 35 x 86 x 86 mm, with an 86 mm face width.

Yes. The UAE commonly uses 230V, 50Hz electrical systems and BS-style Type G plugs and 13A socket outlets, making this 250V AC socket suitable for many UAE residential and commercial installations. The complete installation must comply with the applicable emirate authority requirements, project specifications and current electrical regulations.

Single-pole switching means the socket switch interrupts the live conductor while the neutral connection remains continuous. Correct polarity and conductor identification are essential, so the socket should be wired and tested by a qualified electrician.

The integrated LED provides a clear visual indication of the socket or connected-circuit status. This helps users identify whether the outlet is switched on, although the exact LED behaviour should be confirmed from the supplied ABB wiring instructions because indicator configurations can vary.

It can supply compatible BS 13A plug-equipped appliances whose current and total electrical load remain within the socket rating and the capacity of the circuit. Typical applications include televisions, computers, lamps, chargers and suitable small appliances. High-load equipment must be checked against its nameplate rating and the circuit design before connection.

Isolate and verify the electrical supply before work begins. Install a compatible concealed wall box, route the approved circuit conductors, terminate live, neutral and earth at the marked terminals, secure the mechanism without trapping cables and fit the matching frame. The electrician should then perform polarity, earth continuity, insulation and functional tests before energising the circuit.

A compatible 1-gang concealed back box with sufficient internal depth is required. The product dimensions are approximately 35 x 86 x 86 mm, but available cable space, terminal clearance and the wall finish must also be considered. Confirm the back-box compatibility and mounting centres against the ABB Millenium installation drawing before construction or fit-out work.

Yes, it can be incorporated into blockwork, plastered walls or drywall partitions when a suitable flush box and installation method are used. The box should be level, firmly secured and positioned to finish correctly with the final plaster, tile, stone or wall panel surface.

Yes. Its matt gold finish is well suited to villas, hotels, offices, retail spaces and premium apartment fit-outs where electrical accessories form part of the interior design. For a consistent appearance, coordinate the socket with compatible ABB Millenium frames and accessories from the same finish range.

Use in kitchens or other potentially damp areas depends on the installation zone, local regulations and required ingress protection. No outdoor or weatherproof IP rating is stated for this model, so it should not be assumed suitable for exposed, wet or dusty locations. Use an appropriately rated weatherproof accessory where moisture or outdoor exposure is expected.

The circuit should have correctly selected overcurrent protection, earthing and any residual-current protection required by the applicable UAE authority, project specification and installation location. Cable size, circuit arrangement, fault level, voltage drop and connected load must be assessed by the project electrician or electrical engineer.

Only if the equipment has a compatible 13A plug and its running current, starting current and duty cycle remain within the outlet and circuit ratings. Large power tools, welders, compressors and other high-demand construction equipment may require industrial sockets or dedicated circuits rather than a standard 13A outlet.

Before handover, the installer should check terminal tightness, conductor identification, earth continuity, insulation resistance, polarity, protective-device operation and the function of the switch and LED. Testing should be completed using calibrated instruments and recorded in accordance with the project's inspection and commissioning requirements.

Switch off or isolate the circuit before cleaning. Wipe the faceplate gently with a soft, dry or slightly damp cloth, then dry it immediately. Avoid abrasive pads, solvents, acidic cleaners and excessive moisture because they may damage the matt gold surface or enter the electrical mechanism.