20L Base, 5L Hardener - Flake Grey, 3.6L Base, 900ML Hardener - Flake Grey, طلاء آسيان برجر ،حماية الأرضيات بطبقة إيبوكسي عازلة طبقة حماية إيبوكسي علوية لحماية الأرضية DPL 5 USG

The product should not be applied if the relative humidity exceeds 85% or if the substrate temperature is within 3°C of the dew point. The surface must be clean, dry, and free from contaminants, with new concrete cured for at least four weeks before application.

The mixing ratio for this epoxy coating is 6 parts base to 1 part hardener by weight. Proper mixing is crucial to ensure optimal performance and durability of the coating.

The coverage area is approximately 10.4 m² per liter at a dry film thickness (DFT) of 50 microns. Actual coverage may vary based on surface conditions and application methods.

At a temperature of 25°C, the touch dry time is around 9 hours, hard dry time is approximately 12 hours, and it can be recoated after 12 hours. Full curing takes about 7 days under optimal conditions.

Users should avoid contact with skin and eyes and wear suitable protective clothing such as gloves and goggles. The product is highly flammable; therefore, it should be kept away from heat sources and open flames.

Yes, the Floor Guard Epoxy Top Coat can be used for both interior and exterior applications. Its chemical resistance makes it ideal for various environmental conditions.

The epoxy top coat should be stored in a cool, shaded, and dry area. It has a shelf life of 12 months when kept in its original tightly closed container away from direct sunlight and excessive heat.

This epoxy top coat is designed for mild industrial floors, including parking areas, walkways, and traffic zones. It is also suitable for battery rooms and equipment rooms not subjected to heavy movements.

It offers good chemical and hot water resistance, with a dry heat resistance up to 120°C. The recommended dry film thickness (DFT) is between 50-75 microns.

Surfaces must be clean, dry, and free from contaminants like salts and dirt. Concrete substrates should be free of laitance, which can be removed by wire brushing, acid etching, or sweep blasting.

The preferred method is airless spray with a tip size of 0.38-0.48 mm and pressure between 130-160 kg/cm². It can also be applied using a brush or roller, but additional coats may be needed to achieve the desired thickness.

Like all epoxies, this product will chalk when exposed to direct sunlight. It is better suited for interior or shaded areas.

It provides a durable finish with scratch and impact resistance, excellent adhesion, and superior stain protection. It is ideal for high-traffic areas.

While it can be used in some exterior applications, its UV resistance is limited, making it more suitable for interiors or shaded environments.