أنابيب أطلس البلاستيكية (PVC) مقاس (6") طول (5.9M) بمعيار (Cl-E) يباع بالقطعة

Key specs: 6-inch diameter (nominal), 9.5 mm thick wall, length 5.9 meters, material PVC (Polyvinyl Chloride), brand CL-E Atlas. It’s intended for standard solvent-weld fittings compatible with 6-inch PVC pipe.

Yes. It’s suitable for residential or commercial plumbing runs, irrigation systems, and hydroponic setups where a robust PVC pipe is appropriate. Confirm compatibility with your system’s fittings and pressure requirements before use.

To install: measure and mark the cut, cut square with a pipe cutter, deburr the cut ends, dry-fit with the chosen 6-inch PVC fittings, then apply PVC primer and solvent cement to both the pipe and fittings before joining. Hold the joint steady for a short time to ensure a secure bond.

Use standard 6-inch PVC pipe fittings designed for solvent-weld joints. Ensure the fittings are compatible with the pipe’s nominal size and meet your project’s pressure requirements.

Wear eye protection and gloves when cutting or beveling to avoid injuries from sharp edges. Work in a well-ventilated area when using solvents, and keep PVC dust away from the eyes and lungs. Store pipes away from direct sun and heat sources to prevent deformation.

Store in a dry, shaded area on a flat surface to prevent warping. Keep the pipe elevated off the ground if possible and avoid stacking heavy loads on top. Protect from prolonged direct sunlight when not in use to minimize aging.

Compared to other PVC pipes on Fepy, this 6" CL-E Atlas pipe offers a thicker wall (9.5 mm) for added durability in larger-diameter runs. If you need a slightly smaller size or different wall thickness, you might consider alternatives such as the 4" or 8" variants available on Fepy with similar material and joint types. For direct comparisons, see these related options on Fepy:

Common use cases include building or upgrading residential plumbing lines, running irrigation or drainage in gardens, setting up larger-scale hydroponic systems, and using PVC pipe in DIY construction projects where corrosion resistance is beneficial.

Check that the fittings are labeled for 6-inch PVC pipe and use solvent-weld joints. Confirm pipe standards (e.g., wall thickness and pressure rating) match your project requirements, and ensure components are designed for the same nominal size.

PVC is widely used and recyclable in many regions. Follow local building codes for material approval, and dispose of any waste or off-cuts according to local regulations. Use compatible, code-approved cement and primers for safer and compliant installations.

For alternatives on Fepy, you can compare similar Atlas CL-E PVC pipes in different sizes or thicknesses. Here are direct product links to related options you might consider (all are available on Fepy):

Best practices include clean, square cuts; proper deburring; dry-fitting before cementing; using the correct amount of primer and cement; and ensuring a full, unobstructed solvent-weld joint. Allow joints to cure per product recommendations before pressurizing the system.