أداة (ريشة) مثقب ديوالت نوع (SDS+) قياس (150mmX210mm) قطر (10mm)

Diameter: 10 mm; flute length: 150 mm; overall length: 210 mm; shank: SDS+; tip: tungsten carbide with a centric design; reinforced rock carbide head for durability; intended for concrete, brick, and stone drilling in combination with compatible SDS+ hammer drills.

The tungsten carbide tip provides fast material penetration and longer wear life, while the reinforced head improves durability and reduces bit slip under tough masonry conditions. The centric tip geometry also helps maintain stability and accurate drilling.

This bit is optimized for concrete, brick, and stone. It is not intended for drilling metal and may not perform optimally in plaster or softer substrates unless used with masonry drilling techniques.

1) Ensure the drill is in SDS+ hammer mode and the bit is fully seated in the chuck. 2) Mark your target and start drilling at a low speed with light pressure to establish a guide. 3) Gradually increase speed and apply steady, moderate pressure; avoid side loading. 4) Periodically pause to cool the bit if drilling deep holes. 5) After drilling, carefully withdraw the bit while the drill is still running briefly to clear debris. 6) Inspect the bit and clean before storage.

Wear eye protection, hearing protection, and a dust mask; secure the workpiece to prevent movement; avoid loose clothing or jewelry that could get caught; use dust extraction if available; monitor for overheating and stop if the bit dulls or resists properly.

Ideal for anchor installation, conduit or pipe runs, and masonry drilling in concrete walls, floors, and brickwork where deeper holes are required thanks to the 210mm overall length and 150mm flute depth.

This Dewalt bit emphasizes fast penetration and durability with a carbide tip and reinforced head, along with a centric tip for reduced wandering. Other 10mm SDS+ bits on Fepy.com may vary in tip geometry, length, and head reinforcement, which can affect drilling speed, bit life, and suitability for specific masonry substrates.

Yes, there are other 10mm SDS+ drill bits from Dewalt and other brands with different flute lengths, overall lengths, and tip designs. Review the 10mm masonry bit category on Fepy.com to compare options and pick the one that best fits your project’s depth and material needs.

Use appropriate drilling speeds for masonry, avoid excessive side loading, periodically cool the bit to prevent overheating, keep the bit clean of debris, and store it in a dry place. Matching the drill’s power and hammer action to the bit’s design also helps maximize life.

If you’re not satisfied, check the seller’s return terms on Fepy.com. Typical considerations include returning unused items in original packaging within the policy window and providing proof of purchase. Contact the seller for return instructions if needed.