EcoFlow 100W Rigid Solar Panel - 2 Pieces

The listed panel dimensions are 980 × 586 × 30 mm, and the stated net weight is 6.2 kg. Buyers should confirm whether the supplied weight refers to one panel or the complete package before planning vehicle payloads, roof loading, lifting or mounting arrangements.

The two panels provide a combined rated capacity of up to 200W under standard laboratory test conditions. Actual UAE output varies with solar intensity, panel angle, temperature, dust, shading, cable losses and the connected power station's input limits. Strong sunshine is beneficial, but very high panel temperatures can reduce instantaneous output, so airflow below the panels is recommended.

Compatibility depends on the power station's solar input connector, permitted voltage range, maximum current and maximum input wattage. Before connecting one or both panels, compare the panels' open-circuit voltage, operating voltage and short-circuit current shown on their labels or manual with the power station specifications. Use only compatible EcoFlow or manufacturer-approved cables and adapters.

The correct arrangement depends on the connected charge controller or EcoFlow power station. A series connection increases voltage, while a parallel connection increases current. The combined open-circuit voltage and short-circuit current must remain within the equipment's solar input limits, including the effect of temperature. If the required configuration is uncertain, use a qualified solar installer or electrician rather than combining panels by trial and error.

Select a structurally sound, largely shade-free location and position the panels for good solar exposure. Secure the rigid aluminium frames with compatible brackets and corrosion-resistant fasteners, maintain ventilation below the modules, route cables away from sharp edges and hot surfaces, and provide strain relief at connectors. Do not drill into the solar cells or unapproved areas of the frame. Roof, caravan and cabin installations should also be checked for waterproofing, wind uplift and safe cable entry.

For a fixed installation in the UAE, panels generally perform well when facing approximately south with an appropriate tilt, subject to the site's roof layout and shading. The optimum angle can vary by emirate, season and operating objective. Avoid shadows from parapets, water tanks, HVAC equipment, scaffolding or nearby buildings because even partial shading can significantly reduce charging performance.

The panels have an outdoor-ready rigid construction suited to camping, travel and fixed outdoor use. For UAE conditions, allow rear ventilation, inspect connectors for dust or moisture, and clean accumulated sand from the glass. Do not assume a specific ingress-protection or temperature rating unless it is confirmed on the product label or EcoFlow technical documentation, and avoid exposure beyond the manufacturer's stated limits.

Switch off or disconnect the solar charging circuit according to the equipment instructions, allow hot panels to cool, and remove loose dust with clean water and a soft, non-abrasive cloth or sponge. Avoid harsh chemicals, metal tools, pressure washing and cleaning during peak midday heat, as sudden temperature changes may damage the surface. Cleaning frequency should reflect local dust, sandstorm, bird-dropping and coastal salt exposure.

Yes, the set can help recharge a compatible portable power station used for site lighting, communication devices, surveying equipment, laptops, cameras and other appropriately rated low-load equipment. It is not a substitute for an approved temporary electrical distribution system and should not be relied upon to run heavy construction tools unless the connected power station has adequate continuous output, surge capacity and battery storage.

Yes, their rigid aluminium frames support fixed mounting on suitable caravans, cabins, site offices and similar structures. The supporting surface must safely carry the panel and mounting-system loads, including UAE wind uplift and vibration during vehicle travel. Use suitable brackets, maintain roof waterproofing and verify vehicle clearance, cable routing and payload requirements before installation.

No, solar panels should not normally be connected directly to household appliances or an unregulated battery. They must feed a compatible EcoFlow power station or a correctly specified solar charge controller and battery system. The controller regulates charging and helps protect the battery from unsuitable voltage or current conditions.

Not by itself. These panels are primarily intended to provide DC solar input to compatible portable power equipment or a properly engineered off-grid system. A grid-connected building installation requires approved inverters, protection devices, isolation, metering and authority approvals. In the UAE, installers must follow the applicable requirements of the relevant emirate's utility, municipality, civil defence authority and current electrical regulations.

Confirm the mounting surface capacity, wind resistance, cable size, connector compatibility, polarity, system voltage and charge-controller limits. Keep conductors protected from abrasion and standing water, avoid working on hot panels or roofs during extreme heat, and use appropriate fall protection. Permanent building or site installations should be completed or reviewed by a qualified professional in accordance with applicable UAE electrical, structural and fire-safety requirements.

A 100W rating is measured under standard test conditions rather than every outdoor condition. Reduced production can result from high cell temperature, haze, dust, cloud cover, incorrect orientation, partial shading, cable losses, connector resistance or a power station that limits solar input. Inspect both panels separately if output drops unexpectedly, and verify that the receiving battery is not already full or restricting charge power.