كوع السباكة البلاستيكي (PVC) من (ERA) بزاوية (45) قياس (63mm) يباع (Per Piece)

Key specs: 45-degree angle, made from high-quality PVC, designed to fit standard PVC pipes, corrosion- and crack-resistant, recyclable, sold per piece.

Best for plumbing runs that require a gentle bend around tight corners, drainage, irrigation lines, or any PVC piping installation where a 45° bend is needed to reduce pressure loss and improve flow around obstacles.

General installation steps: 1) Cut the pipe ends square and deburr. 2) Dry-fit to verify alignment. 3) Apply appropriate PVC primer (if required) and cement to the pipe ends. 4) Insert the elbow and hold until the cement sets. 5) Wipe away excess cement and allow proper cure time before pressurizing the system.

This elbow is intended for standard PVC piping. Ensure the pipe diameter matches the elbow’s nominal size and that the system materials are rated for the intended use (e.g., potable water vs. non-potable).

The elbow is designed for PVC piping; for potable water applications, verify that the product is rated for potable water and complies with local codes and standards before installation.

Use this elbow only with pipes that match its compatible nominal size. Mixing sizes can lead to leaks or improper fits. If you need different sizes or angles, check other Fepy PVC fittings designed for those specifications.

The elbow offers crack-, rust-, and corrosion-resistant performance, contributing to a long service life in appropriate PVC piping environments. Longevity depends on usage conditions, exposure, and proper installation.

Yes, this elbow is described as easily recyclable, supporting environmentally friendly disposal at end-of-life where recycling facilities permit.

A 45° elbow provides a gentler bend, reducing pressure loss and turbulence compared to a sharp 90° bend. It’s often easier to install around tight corners and can result in smoother flow for certain piping layouts. For alternatives on Fepy, you can consider: https://fepy.com/product/era-90-degree-pvc-elbow-per-pcs, https://fepy.com/product/pvc-elbow-90-degree-per-pcs, and https://fepy.com/product/pvc-elbow-45-degree-per-pcs.

Tips: ensure ends are cut square and deburred, use fresh primer and PVC cement appropriate for your system, apply evenly, insert fully, and allow adequate cure time before pressurizing. Verify pipe material compatibility and follow local code requirements.

If you’re not satisfied, check Fepy’s standard return policy for PVC fittings. Returns may be allowed within a set window, typically with conditions about unused condition and original packaging. Contact Fepy support for specifics on this product.