طلاء المينا الاصطناعية الزيتي من شركة الأصباغ الوطنية ناشونال لون (650 Post Red) سعة (18L)

National Paints Exterior Emulsion is typically an alternative exterior finish with a different formulation and appearance. Compare them at: https://fepy.com/product/national-paints-exterior-emulsion

National Paints Gloss Enamel focuses on a higher-gloss finish with similar durability. For a glossy, heavy-duty look, compare both at: https://fepy.com/product/national-paints-gloss-enamel

It offers a durable, long-lasting finish with good chip and abrasion resistance, plus low VOCs, which can reduce maintenance and touch-ups over time.

Yes, it is formulated as a low-VOC product to reduce environmental impact and odor during application.

Coverage depends on surface porosity and application method. Check the product can for the stated coverage rate per liter for your specific surface.

For optimal durability, follow the guidance on the product label regarding the number of coats and drying times. Drying can be affected by temperature and humidity, so adjust accordingly.

Priming is advised on bare wood, metal, or highly porous surfaces. On previously painted surfaces, inspect adhesion, lightly sand, clean, and then apply the enamel.

Ensure the surface is clean, dry, and primed where required. Stir thoroughly before use, apply with your preferred method (brush, roller, or spray), and avoid heavy coats. Allow adequate drying time between coats as indicated on the product label.

The formulation delivers good resistance to moisture, mildew, UV fading, and general weathering, making it a solid choice for both indoor and outdoor applications.

National Paints Synthetic Enamel is a fast-drying, high-quality synthetic enamel paint based on modified alkyd resin. It provides a tough, flexible, high-gloss finish with excellent adhesion and durability for interior and exterior surfaces.

It is suitable for interior and exterior walls, as well as wood, metal, masonry, and concrete surfaces, provided the surface is clean, dry, and properly prepared.

National Paints Synthetic Enamel is a high-performance finish designed for interior and exterior surfaces. It provides a durable, chip- and abrasion-resistant coating with low VOC, suitable for high-traffic and high-moisture areas.

National Synthetic Enamel Gloss II has a touch dry time of 2-3 hours, a dry-to-recoat time of 8-10 hours, and a hard dry time of 24 hours when applied at 30°C. Drying time may vary depending on temperature, humidity, air movement, film thickness, and number of coats.

For metal surfaces, the recommended paint system is 1 coat of National Red Oxide Primer (40 microns DFT), 1 coat of National Synthetic Undercoat (40 microns DFT), followed by 2 coats of National Synthetic Enamel Gloss II (40 microns DFT per coat). A suitable primer should be used before the topcoat application for non-ferrous metal surfaces.