PowerSafe Standard LED Strip Light 11W Daylight Double Line 100m Roll PSLED SLSS 11W 2L DL 100M

This strip produces 6500K daylight, giving a cool white appearance. This colour temperature is commonly selected for work areas, utility spaces, corridors, site facilities and other locations where clear, functional illumination is preferred over warm ambient lighting.

The product is identified as a double-line or 2L LED strip, indicating a two-line LED arrangement within the strip design. Buyers should use the exact model number, PSLED SLSS 11W 2L DL 100M, when checking connectors, mounting accessories and electrical components for compatibility.

The supplied product information states an 11W rating but does not define whether it applies per metre, per cutting section or to another configured length. Before calculating circuit load, driver capacity or energy consumption, check the product label and manufacturer documentation for the precise rating basis.

It can be considered for compatible linear-lighting applications such as corridors, coves, shelves, display areas, utility rooms, temporary site facilities and selected architectural details. The installation location must match the strip's stated environmental rating, electrical requirements and permitted mounting method.

Do not assume that the full 100 m roll can be energised as one uninterrupted run. Maximum run length depends on the operating voltage, conductor capacity, voltage drop, heat management and the manufacturer's connection method. Long construction runs may require approved cut sections, separate feeds or dedicated accessories.

First confirm the operating voltage, cutting intervals, maximum run length and required connector or power component from the product label. Isolate the electrical supply, prepare a clean and stable mounting surface, route the strip without sharp bends, and cut only at marked points. Use compatible terminations, observe polarity where applicable, insulate all connections and test the installation before final handover. Fixed electrical work should be completed by a qualified electrician.

The installer should verify the supply voltage and frequency, connected load, cable size, protective device, earthing requirements and compatibility of any driver, rectifier or connector. Installation should follow the manufacturer's instructions, applicable UAE electrical requirements and the rules of the relevant local authority, such as DEWA, ADDC or the authority serving the project location.

Outdoor suitability cannot be confirmed because an IP rating is not provided in the listed specifications. For exposed, wet, dusty or high-humidity locations, verify the strip's IP rating and use appropriately rated enclosures, connectors and power components. It should not be installed outdoors solely on the basis of its LED construction.

Avoid placing the strip next to high-heat equipment, inside unventilated cavities or on surfaces that exceed the manufacturer's temperature limits. Suitable mounting channels and ventilation may assist with heat management, depending on the approved installation method. For outdoor or semi-outdoor projects, also protect the system from direct sunlight, dust, moisture and water ingress.

No. The listed product attributes identify this LED strip as non-dimmable. It should not be connected to a dimmer unless the manufacturer provides explicit written confirmation and specifies compatible control equipment.

Cutting should only be carried out at the designated cut marks specified by the manufacturer. Cutting elsewhere may damage the electrical circuit or leave a section unusable. Confirm cut intervals before setting out the installation, and reseal or insulate cut ends with compatible components where required.

Measure the complete lighting route and allow for approved cutting intervals, corners, joints, termination points and reasonable installation waste. Contractors should also calculate the electrical load using the confirmed wattage basis, account for voltage drop, and schedule compatible feeds, connectors, mounting channels and protective accessories.

Confirm the model number PSLED SLSS 11W 2L DL 100M, 100 m roll length, 6500K daylight colour, double-line configuration and non-dimmable operation. Also verify operating voltage, IP rating, dimensions, cutting interval, maximum run length and required power accessories, as these details are not fully stated in the available product data.

A 6500K cool white output is frequently chosen for functional spaces where a bright-looking, task-oriented environment is desired. The 100 m roll supports quantity planning for larger linear-lighting layouts, while the exact suitability for each UAE project must be confirmed against the consultant's lighting design, approved material schedule and local authority requirements.