أنابيب البولي فينيل كلوريد (PVC) قياس (1") طول (5.8MTR) – تباع بالقطعة

Material: high-grade PVC. Outside diameter is 1 inch, with a long 5.8 meter length. Features smooth interior walls to minimize pressure loss and improve flow efficiency. The pipe is designed to be weatherproof and corrosion-resistant and tested to exceed industry safety and performance standards.

Ideal for water supply lines, irrigation runs, drainage systems, and general conduit applications where a larger interior diameter and longer run are beneficial. Suitable for non-hot water, non-combustible, non-pressurized or moderate-pressure installations depending on fittings and system design.

Cut to length with a PVC cutter, deburr the cut edge, and dry-fit with compatible PVC fittings. Clean both pipe end and fittings, apply PVC primer if required, then use solvent cement or appropriate mechanical couplings to create a secure, watertight joint. Always follow local codes and use the correct size fittings for a true 1-inch connection.

Use a sharp PVC-rated cutter to achieve a clean end. Deburr the inside and outside edges to prevent catching and ensure a smooth fit with fittings. After cutting, dry-fit before final joining to confirm alignment and avoid stressing joints.

Yes, it’s designed to be weatherproof and corrosion-resistant for outdoor use. While PVC is durable, avoid prolonged direct sunlight without protection where required by local codes, and store it in a shaded area when not installed.

Both are 1-inch pipes, but the 5.8m length is slightly shorter than a typical 6m option, which can affect fit in long unobstructed runs. If you need a longer continuous run with fewer joints, the 6m variant might reduce the number of fittings you need. Compare at: https://fepy.com/product/1in-pvc-pipe-6m

The 3m option offers a shorter, more flexible installment path and can reduce excess material in tight spaces. For longer installations, the 5.8m version minimizes joints and potential leak points. Compare at: https://fepy.com/product/1in-pvc-pipe-3m

Handle and cut pipes with appropriate eye and hand protection. Use approved primers and cement for joints where required by local codes. Do not burn PVC, and follow local plumbing standards for potable vs non-potable uses. The pipe is designed to meet industry safety and performance standards.

This PVC pipe is suitable for standard water and irrigation applications per typical non-hot-water use cases. For potable water or high-pressure requirements, verify local codes and ensure you pair the pipe with appropriate rated fittings and pressure guidelines. Do not assume suitability for hot water unless explicitly rated.

Store flat, off the ground, away from direct sun when possible, and keep in a cool, dry place. Transport the pipe flattened or supported to avoid bending or kinking. Avoid dropping or applying heavy impact to maintain smooth interior and exterior surfaces.

The 1" x 5.8m PVC Pipe offers a long, uninterrupted run with a larger interior diameter for efficient flow, reducing the number of joints and fittings needed. Its durability and weather resistance can lower maintenance costs over time, delivering good long-term value for plumbing and irrigation projects.