قرص القطع الماسي توتال منخفض السماكة قياس (7") للاستخدام الرطب موديل (TAC2131801HT)

It's designed for delicate materials such as glass, ceramic tiles, porcelain, and thin natural stone. It excels at producing precise, chip-free cuts on these substrates. It is not intended for metal cutting.

Key features include an ultra-thin edge for reduced waste and precise cuts, professional-grade diamond grit for consistent performance, wet-use compatibility to improve cooling and finish, and a compact, durable construction suitable for professional jobs.

The disc is designed to fit standard saws and tool heads that accept common diamond-disc attachments. Ensure your saw accepts a compatible disc diameter and arbor size, and that you can provide a steady water supply for wet cutting during operation.

Steps: (1) power off and unplug the tool, (2) verify the disc diameter matches your saw’s requirement, (3) mount the disc securely with the proper arbor nut, (4) connect a steady water supply for cooling, (5) start at a low speed and feed material steadily without forcing the cut, and (6) keep the disc and material well-wetted during the cut to minimize chipping and overheating.

Always wear eye protection and gloves, ensure the work area is stable, and keep electrical components away from water sources. Inspect the disc for cracks or damage before use, avoid side loading or twisting, and stop immediately if you notice glazing, unusual vibration, or excessive heat.

Use cases include precision scoring and cutting of ceramic tiles, glass panels, porcelain, and thin stone pieces for mosaics, countertops, bathroom and kitchen tiling projects, and other delicate ceramic or mineral substrates where clean, accurate cuts are essential.

Compared to the Total Ultrathin Dry Diamond Disc (https://fepy.com/product/total-ultrathin-dry-diamond-disc), this Wet Diamond Disc benefits from active cooling with water, which helps prevent overheating and reduces chipping in damp environments. Compared to the Precision Wet Diamond Disc (https://fepy.com/product/precision-wet-diamond-disc), the Ultrathin Wet Disc emphasizes ultra-thin edge for maximum material preservation and minimal kerf, while the Precision Wet Disc may offer different grit or edge geometry optimized for specific precise tasks.

Check that the disc is properly mounted and not under excessive load. Ensure the material is adequately supported and the cutting surface is stable. Verify a steady water supply is present to avoid overheating, and adjust feed rate to a steady, moderate pace. If you notice glazing or resistance, stop and inspect for cracks, edge damage, or debris buildup on the disc.

After use, clean off residue with a soft brush and water. Dry the disc to prevent corrosion, then store in a dry, protected area away from impact. Regularly inspect for wear or cracks; replace if any damage is detected to maintain cut quality and safety.

For professional results on delicate materials, the ultrathin design reduces material waste and delivers precise cuts, which can lower scrap and improve turnaround. Consider the material you work with, the required finish, and whether you need wet-cutting capability. If you frequently cut glass or ceramic tiles, this disc is well-suited to long-term, high-precision work.

Use a steady, moderate feed rate and maintain a continuous water spray or flow to keep the edge cool and reduce heat buildup. Avoid high speeds that can cause overheating or glazing, and adjust water amount based on material hardness and disc condition to maintain a clean, controlled cut.