Atlas PVC Reducer Bush, 160mm x 110mm, Heavy-Duty

Specs: reducer size 160 mm to 110 mm; heavy-duty PVC construction; smooth inner finish to minimize friction; high pressure tolerance for industrial use; corrosion resistant for water and chemical systems; accurate fit for a seamless pipe transition; suitable for industrial plumbing and large-scale irrigation.

The reducer bush is installed between two PVC pipe ends. For most installations you will apply PVC primer and cement to both ends, align the 160 mm and 110 mm ends with the respective pipes, and insert the bush so the joints are fully seated. Allow the joints to cure per the cement manufacturer's directions and perform a leak check.

Yes, it is designed for heavy-duty, high-pressure industrial use. Always ensure the entire system, including pipes, fittings, and cement joints, is rated for the operating pressure and follow best practices for install and testing.

Steps: 1) cut and deburr the pipe ends; 2) clean the ends and apply PVC primer; 3) apply PVC cement to the 160 mm and 110 mm ends; 4) slide the reducer onto the larger pipe and seat it; 5) quickly connect the smaller pipe end and assemble; 6) hold the joints steady until the cement cures; 7) test for leaks under pressure.

Wear eye protection and gloves when handling solvents and cement. Work in a well-ventilated area. Ensure pipe ends are clean and free of burrs to prevent fitting damage. Verify chemical compatibility with the PVC material and any fluids in the system, and avoid exposing PVC to high heat or incompatible chemicals.

Common uses include industrial plumbing networks, large-scale irrigation systems, municipal water transfer lines, and chemical-processing setups where a durable, leak-resistant 160 mm to 110 mm transition is needed.

Comparable options on Fepy include: - Atlas PVC Reducer Bush, 180mm x 110mm, Heavy-Duty: https://fepy.com/product/atlas-pvc-reducer-bush-180mm-110mm-heavy-duty - Atlas PVC Reducer Bush, 160mm x 90mm, Heavy-Duty: https://fepy.com/product/atlas-pvc-reducer-bush-160mm-90mm-heavy-duty - Atlas PVC Reducer Bush, 200mm x 150mm, Heavy-Duty: https://fepy.com/product/atlas-pvc-reducer-bush-200mm-150mm-heavy-duty - Atlas PVC Reducer Bush, 140mm x 100mm, Heavy-Duty: https://fepy.com/product/atlas-pvc-reducer-bush-140mm-100mm-heavy-duty

Determine the pipe diameters on either side of the section you’re connecting. A reducer bush should match the larger pipe on one end and the smaller pipe on the other (in this product’s case, 160 mm to 110 mm). Also consider flow requirements and system pressure; if in doubt, consult a piping engineer or compare with similar fittings on Fepy.

Yes, you can chain reducers in series to step down across multiple sizes, provided each joint is properly cemented and the alignment is maintained. Check that each subsequent reducer’s ends match the pipe sizes and your system’s pressure rating remains within limits.

This reducer bush is designed for heavy-duty, long-term performance with a smooth inner finish and corrosion resistance, which helps reduce leaks and friction losses over time. If you compare it with other heavy-duty PVC reducers on Fepy, consider material quality, fit precision, and the expected service life in your application.

If you need to return this item, start by contacting Fepy support to authorize a return and obtain an RMA. Ensure the item is unused and in original packaging where possible, and follow the provided return instructions to receive a refund or exchange.