Bosch 2609256908 5/6/8mm SDS-Quick Concrete Drill Bit-Set

The set contains 5 mm, 6 mm, and 8 mm bits. Use 5 mm for small pilot holes or precise anchors, 6 mm for typical masonry fasteners, and 8 mm for larger holes needed for pipes, plugs, or larger anchors in concrete or masonry.

Yes. These bits are designed for concrete, stone, and masonry, and they are carbide-tipped for enhanced durability and longer tool life in tough materials.

They’re ideal for Bosch UNEO 3‑in‑1 cordless SDS hammer/drill and driver, Bosch EasyHammer rotary hammers, and drills with three‑jaw chucks (with appropriate chuck compatibility).

Power off your tool, insert the SDS-Quick shank into the chuck or SDS adapter until seated, and release the collar to lock. To remove, release the collar or tool’s quick‑change mechanism and pull the bit out. The included storage case helps keep bits organized between uses.

Use steady, moderate pressure and maintain a consistent drilling speed. Let the carbide tip cut without forcing the bit. Keep the tip cool with intermittent drilling or light lubrication if permitted by your tool and material, and withdraw the bit periodically to clear debris and reduce heat buildup.

Carbide-tipped bits are built for durability in hard materials. Store them in the included case, avoid bending or impact damage, and inspect the bits for wear or chipping. Replace if tips are severely worn to maintain performance.

If you’re weighing options on Fepy, you can look at these similar SDS-Quick sets: Bosch 2609256907 SDS-Quick Concrete Drill Bit Set (5/6/8 mm) — https://fepy.com/product/bosch-2609256907-sds-quick-concrete-drill-bit-set and Bosch 2609256909 SDS-Quick Concrete Drill Bit Set (5/6/8 mm) — https://fepy.com/product/bosch-2609256909-sds-quick-concrete-drill-bit-set. For additional brands, DeWalt SDS-Plus 5/6/8 mm — https://fepy.com/product/dewalt-sds-plus-concrete-drill-bit-set-5-6-8mm and Makita SDS-Plus 5/6/8 mm — https://fepy.com/product/makita-sds-plus-concrete-drill-bit-set-5-6-8mm. These provide comparable performance with variations in tip geometry and shank styles.

These bits are SDS-Quick shank bits designed for SDS-compatible hammers and tools. They can be used in drills with three‑jaw chucks if you have an appropriate SDS-to-chuck adapter, but for best performance and to honor the SDS-Quick design, using an SDS hammer or the Bosch UNEO is recommended.

Choose 5 mm for small pilot holes or tight anchors, 6 mm for common masonry fasteners and anchors, and 8 mm for larger holes needed for bigger anchors, pipes, or electrical conduits. Consider the anchor size and the required hole diameter to match the bit size.

If you’re not fully satisfied or the item arrives defective, you can initiate a return within the defined return window on Fepy. Ensure the product is unused and in its original packaging; follow the returns process on the site to receive a refund or replacement per Fepy’s policy.