Cosmoplast PPR Tee 40mm, Equal Branch, Fusion-Weld, Low Head Loss

‘Equal Branch’ means the branch inlet and the main run have the same nominal diameter, providing a symmetrical tee that preserves flow characteristics and minimizes turbulence at the branch.

It’s made from high-quality PPR material for durability and long service life, offers leak-proof fusion-welded joints, is heat and pressure resistant, corrosion-free, non-toxic for drinking water, compact in design, and suitable for plumbing, irrigation, and industrial applications.

Fusion welding uses heat and pressure to fuse the pipe and fitting into a single, leak-free joint. Follow the approved fusion parameters provided by Cosmoplast and perform a pressure test and commissioning per your project spec to ensure a proper seal.

This 40mm tee is designed for 40mm PPR piping, and it’s suitable for hot and cold water distribution in domestic and light industrial systems that use PPR, accommodating typical residential and floor-distribution scenarios.

Use cases include UAE floor distribution loops, mixing loops in radiant or solar systems, and feeding equipment or appliances from a main PPR distribution line.

Yes. Step-by-step: (1) cut the 40mm pipe square and deburr, (2) dry-fit to ensure alignment, (3) clean the pipe ends, (4) apply the fusion-welding parameters as specified, (5) fuse the branch and run, (6) allow cooling and inspect the joint, (7) perform a pressure test to verify integrity.

The tee uses non-toxic PPR suitable for drinking water, is corrosion-free, and designed for safe contact with potable water. Follow local codes and use appropriate PPE during installation and testing.

If you’re comparing sizes, you can look at: Cosmoplast PPR Tee 32mm Equal Branch: https://fepy.com/product/cosmoplast-ppr-tee-32mm-equal-branch and Cosmoplast PPR Tee 50mm Equal Branch: https://fepy.com/product/cosmoplast-ppr-tee-50mm-equal-branch

The 40mm size offers a balance between flow capacity and installation footprint. Compared with the 32mm version, it handles higher flow; compared with the 50mm version, it saves space and reduces material cost where the smaller diameter meets system requirements. Each size uses the same fusion-weld principle and non-toxic PPR material, so performance remains consistent across sizes when used in appropriate applications.

With proper fusion-weld installation and normal service conditions, PPR fittings like this tee typically offer long service life with minimal maintenance. Regularly check joints after pressure tests and servicing, and replace any joint that shows signs of leakage or deformation.