Drill Chuck 16mm + Adaptor

Chuck size: 16 mm. Bit capacity: 0.6–8 mm. Thread size: 0.75. Adaptor included to broaden compatibility with various drills. Made from hardened steel for strength and durability.

It’s designed to work with most electric drills. The included adaptor helps fit different drill quill sizes, but always check your drill’s manual for exact compatibility and installation instructions.

1) Power off and unplug the drill. 2) Attach the adaptor to the drill as per the manual. 3) Mount the 16 mm chuck onto the adaptor and secure it. 4) Insert the chuck key, tighten to grip the bit, then remove the key before operating. 5) Verify the setup is snug and test on scrap material before regular use.

1) Unplug the drill. 2) Insert the chuck key into the key slot and turn counterclockwise to loosen. 3) Remove the old bit and insert the new one within the 0.6–8 mm range. 4) Tighten with the chuck key, then remove the key and recheck fit before drilling.

Always wear eye protection, keep fingers away from the rotating bit, and ensure the chuck key is removed after tightening. Do not exceed the bit capacity (0.6–8 mm) or apply side loading. Make sure the drill is off while making adjustments and use proper lubrication if recommended by your drill’s manual.

Bits with shanks from 0.6 to 8 mm fit the chuck. Use straight, undamaged drill bits and avoid worn, dulled, or bent bits to prevent slippage and poor hole quality.

Ideal for DIY projects, woodworking, metalwork, and small pilot-hole tasks where a secure, easily interchangeable bit is needed. The adaptor broadens compatibility so you can use it across different drill brands.

Keep the chuck clean and dry after use. Wipe away dust and moisture, and apply a light coat of lubricant if recommended by your drill’s maintenance guidelines. Store in a dry area and periodically inspect for wear or rust; replace if wear is evident.

If you’re considering alternatives on Fepy, you can compare with these options: Drill Chuck 13mm with Adaptor — https://fepy.com/product/drill-chuck-13mm-adaptor and Half-Inch Drill Chuck Adaptor — https://fepy.com/product/half-inch-drill-chuck-adaptor. Both are similar in purpose and offer different chuck sizes or adaptor configurations to suit your drill model.

Yes. Ensure the bit is fully seated and straight in the chuck, tighten evenly with the chuck key, and avoid applying lateral force while drilling. Use sharp bits, drill at appropriate speeds for the material, and test on scrap material first to confirm stable runout levels.