Fosroc CM210 Nitocote (Liquid 5kg and Powder 18kg) 23kg - Grey

Safety considerations for Fosroc Nitocote products include avoiding ignition sources due to flammability, using personal protective equipment like gloves, eye protection, and respirators during mixing and application, disposing of used containers and excess material according to local regulations, and referring to safety data sheets for full safety information.

Fosroc Nitocote products should be stored in original, unopened containers in a dry, cool, and well-ventilated area, avoiding exposure to direct sunlight, heat, and moisture. The typical shelf life is 12 months from the date of manufacture when stored properly.

Fosroc Nitocote products are typically applied using brushes, rollers, or spray equipment. Surface preparation, mixing ratios, and application techniques vary by product, so following the Technical Data Sheet instructions is important.

The choice of Fosroc Nitocote product depends on the application, substrate, and performance requirements, such as chemical resistance, abrasion resistance, flexibility, and curing conditions. Fosroc technical support can assist in selecting the most suitable product.

Coverage rates for Fosroc Nitocote products vary by product, substrate conditions, and application method, typically ranging from 2-5 m²/L for a single coat application, as provided in individual product Technical Data Sheets.

Fosroc Nitocote CM210 is a two-component, elastomeric cementitious waterproof coating designed for various applications, including potable water retaining structures and swimming pools. It provides excellent crack-bridging capabilities and forms an impermeable membrane upon curing.

Nitocote CM210 is suitable for use in potable water retaining structures, internal basement waterproofing, swimming pools, drainage culverts, and wet areas such as kitchens and bathrooms. It can also be used as a vapor barrier and for damp-proofing facades.

The product withstands high positive (up to 5 bar) and negative (up to 3 bar) hydrostatic pressures, has excellent adhesion to concrete and masonry, and accommodates cracks effectively both before and after immersion. It is also approved for contact with potable water.

At 20°C, the pot life is approximately 2 hours, while at 35°C, it reduces to about 1 hour. This timeframe indicates how long the mixed product remains workable before it begins to set.

After a curing period of 21 days at 23°C, followed by 28 days of immersion at the same temperature, the coating demonstrates resistance to positive water pressure of 5 bar and negative water pressure of 3 bar. It also exhibits dynamic crack accommodation capabilities without failure.

The minimum application temperature for Nitocote CM210 is 5°C. Applying the product below this temperature may affect its performance and adhesion properties.

Nitocote CM210 can be applied using a brush, trowel, or spray methods. For optimal results, it is recommended to finish the surface with a trowel after application to ensure a smooth finish.

Yes, Nitocote CM210 is WRAS approved when cured properly. It meets standards for use in contact with potable water, making it suitable for applications involving drinking water storage and distribution systems.