Gyproc Habito Plaster Board 15 x 1200 x 3000 T/E Edge Steel Grey Face Brown Reverse

The board is 12.5 mm thick with dimensions of 1200 mm by 2400 mm. It is moisture resistant, lightweight yet strong, offering good acoustic performance, plus fire and water resistance. It’s designed to fit standard plasterboard partitions and can be cut and installed quickly.

Habito is engineered for higher impact resistance and durability, making it harder wearing than standard boards. It maintains strong thermal and acoustic insulation while remaining relatively lightweight, making it ideal for high-traffic walls and ceilings or areas needing extra robustness.

Use Habito for interior walls and ceilings in homes and workplaces, especially in high-traffic or moisture-prone areas. It’s well-suited for living rooms, hallways, kitchens, bathrooms and other spaces where a hard-wearing finish is desirable.

General steps: 1) plan and mark lines on studs, 2) cut boards to size with a sharp knife or saw, 3) fix boards to standard plasterboard studs with appropriate screws (spacing per local code), 4) tape and apply joint compound to joints, 5) sand smooth and prime/paint, 6) clean up. Always follow local building regulations and safety guidelines during installation.

Needed items include: a utility knife or saw, straight edge, measuring tape, stud finder, plasterboard screws, a drill or driver, joint tape, joint compound, sanding block, and appropriate PPE (gloves, eye protection, dust mask).

Wear eye protection, gloves and a dust mask when cutting. Lift boards with assistance to avoid strain, secure work area, and dispose of waste responsibly. Cut away from the body and keep cut edges clean to reduce dust and sharp edges.

Habito is designed to meet relevant building regulations and delivers strong impact resistance, good acoustic insulation, and fire/water resistance suitable for interior wall lining. Always verify compliance with local requirements for your project.

Habito offers higher impact resistance and robustness, making it better for high-traffic areas. If you need a standard moisture-resistant option with typical performance, Gyproc Moisture Resistant plasterboard may be sufficient; Habito provides extra durability where it matters.

Yes. Habito can be cut to size using a sharp knife or saw. Score the board on one side and snap along the line, then trim the back with a saw. Always measure carefully and wear safety gear during cutting.

Apply joint tape over the joints, then apply a layer of joint compound, allow to dry, sand lightly, and repeat with additional coats as needed until the finish is smooth and seamless. Prime and paint once fully cured.

If you’re considering alternatives, you can compare these on Fepy: Gyproc Moisture Resistant plasterboard (for standard moisture resistance): https://www.fepy.com/product/saint-gobain-gyproc-moisture-resistant-plasterboard-12-5-x-1200-x-2400mm; Gyproc FireLine plasterboard (fire resistance): https://www.fepy.com/product/saint-gobain-gyproc-fireline-plasterboard-12-5-x-1200-x-2400mm; Gyproc Impact plasterboard (high impact resistance): https://www.fepy.com/product/saint-gobain-gyproc-impact-plasterboard-12-5-x-1200-x-2400mm. These are available on Fepy for side-by-side comparison with Habito.