Features

This water-based finish for the exterior has good hiding power and colour stability and is smooth and simple to apply. APEO, formaldehyde, heavy metals, and other hazardous compounds are absent. is quite low in VOC.

SUGGESTED USE:
Superb for decoration of exterior surfaces.
Substrate:
Cement plaster, concrete, block work, rendered surfaces etc.

PRODUCT DATA.
Packaging size 18L.
Solids by volume 34 ± 2 volume%.
Specific gravity 1.4 Theoretical Only for white colour.
VOC 0 g/l.

APPLICATION DATA.
The product can be applied by:
Roller: Recommended.
Spray: Use airless spray or conventional spray.
Brush: Recommended to paint corners and edges.

GUIDING DATA FOR AIRLESS SPRAY:
Nozzle tip 0.021–0.027".
Spray angle degrees 65–80°.
Pressure at nozzle 140 - 190 kg/cm² (2100 psi).
Cleaning of painting tools:
Water.
Film thickness per coat.
Typical recommended range.
Dry film thickness 30 - 50 µm.
Wet film thickness 90 - 150 µm.
Theoretical spreading rate 11 - 6.8 m²/l.
Thinner: Water.
Dilution: Maximum 10 %.
Conditions for application: The substrate's temperature should be at least 10 °C and 3 °C above the air's dew point, as measured close to the substrate. In small spaces, adequate airflow is typically needed to ensure proper drying.

DRYING PERIODS:
1. The advice given is to repaint using the same type of general paint.
2. If more than one coat is applied, the number, order, and total thickness of the prior applications applied will all affect drying timeframes.
3. Prior to applying the next layer, the surface needs to be dry and clear of any contaminants.

The following values are used to calculate drying time:
Relative Humidity (RH) 50 %
Substrate temperature 10 °C 23 °C 40 °C.
Surface (touch) dry 6 h 3 h 1h.
Hard dry 12 h 6 h 2 h.
Dry to over coat, minimum 6 h 4 h 2 h.

SURFACE PREPARATION:
The substrate must be solid, spotless, dry, and free of dust, laitance, oil, grease, and other contaminants. Form release agents and curing agents must be completely eliminated. Before application, a little sanding with the appropriate abrasive material is advised. Any resulting dust or loose debris must be taken out.

RECOMMENDED PAINT SYSTEM:
Primer
Jotashield Alkali Resistant Primer or Acrylic Emulsion Primer: 1 Coat.
Topcoat: Easycoat M att 2 Coats.
Other paint systems:
Jotashield Penetrating Primer: 1 Coat
Jotashield Penetrating Primer: 1 Coat

STORAGE:
Keep the containers away from heat sources and ignition sources in a dry, cool area that is well-ventilated. According to national regulations, the product must be stored. Containers must remain securely closed. Carefully handle.