M-Seal Epoxy Putty, Fast-Set, Leak-Stop & Gap-Fill

M Seal consists of two parts: a resin and a hardener, which must be mixed in equal volumes. The resin is typically green, while the hardener is black, allowing users to easily identify when a uniform mix is achieved.

The working time for M Seal is approximately 15 to 20 minutes, with a setting time of 60 to 90 minutes. It hardens fully within 1 to 2 hours, depending on environmental conditions.

Yes, once M Seal has fully cured, it can be painted. This allows for aesthetic integration into various applications where appearance matters.

M Seal is versatile and can bond to a variety of surfaces, including ferrous and non-ferrous metals, ceramics, glass, wood, leather, and certain plastics. This makes it suitable for a wide range of repair and sealing tasks.

Proper substrate preparation is crucial for optimal results. Surfaces should be cleaned of rust, dust, and grease, and it is recommended to abrade them before application. Mixing should be done promptly after combining the resin and hardener.

Yes, the cured M Seal exhibits good resistance to moisture, mild acids, and alkalis, making it suitable for use in environments where exposure to such conditions is likely.

You should avoid prolonged contact with the mixed putty on your skin and should not add solvents or excess hardener to the mix, as this can affect the setting time and effectiveness. Proper ventilation is also recommended during use.

M Seal 100g is a two-component epoxy putty used for sealing, joining, fixing, and insulating surfaces. It forms a tough and durable bond on materials such as metals, ceramics, wood, and certain plastics.

To use M Seal, clean the substrate to remove dust or grease, then mix equal parts of the resin (green) and hardener (black) until a uniform colour is achieved. Apply within 5-10 minutes for optimal adhesion.

The setting time for M Seal 100g is approximately 60 minutes at room temperature (30°C). It can be handled after 1-2 hours of curing, depending on environmental conditions.

M Seal has excellent tensile strength (>200 kg/cm²), compressive strength (>400 kg/cm²), and flexural strength (>350 kg/cm²). It also has low water absorption (<0.5%) and can withstand temperatures up to 80°C.

M Seal 100g is waterproof and provides a reliable seal against moisture, making it suitable for water supply lines and underwater repairs.

The hardener may cause skin irritation. It is recommended to wear gloves during mixing and application, wash hands thoroughly after use, and avoid contact with eyes.

Once fully cured, M Seal can be sanded and painted over, making it ideal for both functional and aesthetic repairs.