Mapei Self-Levelling Compound, 23Kg, Suitable for Smoothing Interior Floors Prior to Resilient and Textile Coverings

Key specs include internal and external suitability, rapid water‑based application, odourless drying, cement and anhydride‑free composition, and a general coverage rate of about 8 m2 per kg (coverage varies with thickness and surface). It’s designed for both manual and mechanical application and supports a variety of finishing options.

Mix Ultraplan with clean water to achieve a lump‑free, pourable consistency. Use a trowel for manual application or a mechanical mixer for larger areas. Apply to the prepared substrate and smooth to the required level. Follow the manufacturer’s guidelines for pot life, curing, and any priming that may be needed for porous surfaces.

Suitable substrates include sound concrete and prepared screeds. It can be used to smooth irregular surfaces and prepare substrates for tile, stone, and other finishes. For exterior use, ensure the substrate is appropriate for outdoor levelling and compatible with a cementitious levelling compound.

Ultraplan supports a wide range of finishes, including textured tile, stone, and other surface coverings. The levelling layer provides a uniform base to achieve a high‑quality final surface.

Ultraplan can be applied in varying thicknesses to achieve a level surface suitable for the chosen finish. Thickness guidelines depend on the substrate and the finish, so refer to the product datasheet for specific minimum and maximum recommended thicknesses and any priming requirements.

The product is water‑based and odourless when drying, with a low odor profile. It is cement and anhydride‑free, but you should still use appropriate PPE (gloves, eye protection, and a mask if dust is produced) and follow the SDS and local safety guidelines during handling and application.

Ultraplan is designed for rapid, low‑odour levelling with suitability for internal and external use and finishes like tile and stone. Compared with other levelling compounds on Fepy, Ultraplan emphasizes easy water‑based mixing, fast setting, and flexibility for both small and large projects. For a direct side‑by‑side, you can view similar products like Ardex or Planipatch levelling compounds on Fepy to compare mixing ratios, cure times, and finish options: https://fepy.com/product/ardex-p51-levelling-compound and https://fepy.com/product/mapei-planipatch

The general coverage rate is about 8 m2 per kg. A 23 kg bag would therefore cover roughly 184 m2, depending on surface profile, thickness, and application method. This helps estimate material costs for larger levelling projects and can guide purchasing quantity.

Prepare the substrate by cleaning and removing loose material. If required, prime porous surfaces according to the datasheet. Mix Ultraplan to the specified consistency with clean water, then apply using a trowel or mechanical methods. Smooth to the desired level and allow appropriate curing time before tiling or applying another finish. Protect the levelling layer from foot traffic or loads until fully cured as per the guidance in the datasheet.

Yes. Wear appropriate PPE (gloves, eye protection, and a dust mask if cutting or mixing produces dust). Use in well‑ventilated areas. Store in a dry place away from moisture. Refer to the Safety Data Sheet (SDS) for full hazard and first aid information and ensure compliance with local regulations.

Store the product in a dry, sheltered area in its original sealed packaging. Keep away from moisture and extreme temperatures. Shelf life is typically defined by the manufacturer on the packaging; ensure bags remain sealed until use and check the label before opening.

Fepy offers return options in line with their standard policies for non‑specialist materials. If you need to return, contact Fepy support or review the product page for the return terms applicable to this item.