PowerSafe LED Batten Light 40W Daylight PSLED BL40 DL

This LED batten is suitable for general lighting in dry indoor areas such as offices, shops, workshops, corridors, storerooms, utility rooms, residential service areas and suitable construction-site facilities. The location must be compatible with its IP20 rating and the manufacturer’s installation requirements.

The stated luminous output is 3800 lumens. This makes the fitting suitable for broad, practical illumination, although the required number and spacing of battens should be determined from room dimensions, mounting height, surface reflectance and the target lux level.

A 6500K colour temperature produces a cool, crisp white appearance commonly described as daylight. It is frequently selected for workspaces, utility areas, workshops and commercial interiors where clear, functional illumination is preferred over warm ambient lighting.

Yes. The fitting is rated for 220–240V AC at 50/60Hz, which is compatible with typical UAE low-voltage building supplies when correctly connected. A qualified electrician should confirm the circuit voltage, wiring, earthing arrangements and protective devices before installation.

IP20 indicates protection against access by fingers and solid objects larger than approximately 12.5 mm, but it does not provide rated protection against water. The batten should therefore be installed in a dry indoor location and kept away from rain, washdown areas, condensation and excessive moisture.

No, not in an exposed outdoor location. Its IP20 rating is unsuitable for rain, dust-heavy external environments or water exposure. Outdoor, car-park, garden and open construction applications should use a fitting with an appropriate outdoor IP rating selected for the site conditions.

Isolate and verify the electrical supply before work begins, securely fix the batten to a suitable surface, and connect it only in accordance with the manufacturer’s wiring instructions. Installation should be completed by a qualified electrician using suitable cables, terminals and protective devices. The completed work must comply with applicable UAE wiring regulations and the requirements of the relevant local authority.

It may be fixed to a suitable ceiling or wall where the mounting surface, orientation and supplied fixing method comply with the manufacturer’s instructions. The installer must verify substrate strength, use appropriate anchors, maintain ventilation around the fitting and avoid concealed building services when drilling.

No. This model is specified as non-dimmable and should not be connected to a conventional dimmer. Use a standard compatible switching circuit unless the manufacturer expressly approves another control method.

The manufacturer states a rated lifetime of 25,000 hours under its specified operating conditions. Actual service life can vary with ambient temperature, switching frequency, supply quality, ventilation, installation conditions and maintenance.

The quantity cannot be determined from wattage alone. A lighting calculation should consider floor area, mounting height, required lux level, room use, wall and ceiling reflectance, obstructions and fitting spacing. Contractors and engineers should prepare a suitable lighting layout for workplaces, commercial premises and larger project areas.

The 3800-lumen output can support general illumination in many dry indoor workshops and storerooms. However, detailed assembly, inspection or precision work may require higher maintained lux levels or supplementary task lighting. The final design should follow the project specification and applicable workplace-lighting requirements.

Each fitting has a nominal rated power of 40W and a listed rated current of 300 mA. Designers should use the manufacturer’s electrical data when calculating the connected load and should also assess circuit capacity, protective-device selection, switching arrangements and any LED-driver inrush considerations.

It may be used as an LED alternative where its 3800-lumen output, 6500K colour temperature, physical installation arrangement and electrical rating meet the project requirements. Replacement should not be based on wattage alone; mounting points, room illumination, circuit condition and emergency-lighting obligations must also be checked.