PowerSafe Round LED Panel Light 36W Daylight PSLEDR PL36 DL

This LED panel light can be considered for offices, corridors, reception areas, shops, workshops, utility rooms, residential interiors and suitable construction projects. Its 6500K daylight output is particularly useful where clear, bright-looking illumination is preferred. The fitting's dimensions, mounting method and environmental rating should be checked against the intended location before installation.

A 6500K colour temperature creates a cool white, daylight-style appearance. It can improve visual clarity in work areas, commercial premises, workshops and task-oriented rooms. Buyers seeking a warm or relaxed atmosphere should note that 6500K appears noticeably cooler than warm white lighting.

Yes. Its stated 220-240V AC, 50/60Hz input is compatible with the nominal low-voltage supply commonly used in UAE buildings. A qualified electrician should still verify the circuit voltage, wiring, protective device and connection arrangement before energising the panel.

No. The listed specification identifies this model as non-dimmable. It should be connected to a standard switched lighting circuit and not used with a conventional dimmer unless PowerSafe provides written confirmation of compatibility with a specific control system.

First isolate and verify the electrical supply, then confirm that the ceiling opening or mounting arrangement matches the actual panel dimensions and fixing system. Connect the supplied or specified driver in accordance with its terminal markings, secure the panel without trapping cables, and test the completed circuit. Installation should be undertaken by a qualified electrician following the manufacturer's instructions and applicable UAE authority requirements.

Contractors should verify the model number PSLEDR PL36 DL, 36W connected load, 6500K colour temperature, 220-240V AC supply, ceiling type, panel diameter, cut-out size, mounting depth and driver requirements. They should also confirm the required quantity through a lighting layout or lux calculation rather than selecting fittings by wattage alone.

It may replace a compatible existing fitting, but wattage and shape alone do not guarantee a direct fit. Check the ceiling cut-out, external diameter, recess depth, fixing method, driver space and circuit condition. If the opening differs, ceiling modification or a suitable mounting accessory may be required.

The quantity depends on room dimensions, ceiling height, surface reflectance, required illuminance, panel lumen output and spacing. For construction and commercial projects, a lighting designer or electrical engineer should perform a lux calculation based on the intended activity and applicable project requirements. The 36W rating represents electrical power consumption, not the measured brightness.

Outdoor or wet-area use should not be assumed because an IP rating is not provided in the listed product data. Use it only in locations consistent with the manufacturer's confirmed ingress-protection and operating-temperature ratings. Bathrooms, external soffits, dusty sites and humid service areas may require a specifically rated fitting.

The lighting circuit should comply with the applicable UAE electrical regulations, project specifications and requirements of the relevant local authority or utility, such as DEWA in Dubai or the responsible authority in the installation emirate. Correct cable sizing, earthing where required, circuit protection, isolation, secure connections and safe ceiling clearances must be confirmed by a qualified electrical professional.

Yes. Use 36W as the nominal connected load per panel for preliminary circuit and energy calculations, while also accounting for the driver and any manufacturer-stated tolerances. Electrical designers should consider the number of fittings, circuit capacity, switching arrangement, power factor and possible LED-driver inrush current when finalising circuit schedules.

LED panel lights normally operate through a compatible LED driver, but the supplied components should be confirmed when ordering or inspecting the package. Only use the driver specified for the PSLEDR PL36 DL and ensure its input voltage, output characteristics, power rating and connector arrangement match the panel.

Isolate the power before inspection or cleaning. Remove dust with a dry or slightly damp soft cloth, avoid abrasive products and solvents, and do not spray liquid into the fitting or driver. Periodically check for flickering, discolouration, loose mounting, damaged wiring or excessive heat, with electrical faults handled by a qualified electrician.