Stanley 0-12-315 60mm Bailey Plane Iron Cutter

The blade is constructed from high-quality steel, engineered to hold a sharp edge longer and resist wear during regular planing tasks. This helps maintain consistent cuts over extended use.

Yes. It is designed to fit standard Stanley Bailey planes. For best results, check your plane’s iron seat width and bevel orientation to ensure a proper fit and alignment.

To install: remove the existing blade and lever cap, clean the mating surfaces, place the new iron in with the bevel facing down (toward the wood), seat it evenly, then reattach the lever cap and adjust depth and alignment as needed before use.

Maintain the edge by sharpening on a flat sharpening surface or water/oil stones, ensuring the back is flat and the bevel is evenly ground. Regular honing and periodic flattening of the back will preserve a consistent micro-bevel and clean shavings.

It’s well-suited for fine finishing and precise shaving tasks, edge jointing, smoothing surfaces, and paring end grain. It’s versatile for both hobbyist projects and professional woodworking.

Always wear eye protection, keep hands clear of the blade path, secure workpieces with clamps, and take light, controlled passes to avoid tear-out or kickback. Maintain a sharp edge to reduce the amount of force needed, which also improves control.

Compared with other Bailey-plane irons on Fepy.com, this blade emphasizes durability and a long-lasting edge with easy replacement. For a quick side-by-side view, you can compare with other Stanley irons like the No. 4 and No. 5 variants: https://fepy.com/stanley-no-4-plane-iron and https://fepy.com/stanley-no-5-plane-iron.

Its combination of high-quality steel, maintenance-friendly edge retention, and straightforward replacement process offers long-term usability and cost efficiency, especially for frequent planing tasks.

Store the blade in a dry, clean place, ideally in a protective blade guard or sheath to prevent nicks. Keep it away from moisture to avoid corrosion and handle with care during transport.

Check that your plane’s iron seat width and overall geometry match the blade’s specifications. If you’re upgrading from an older or worn blade, ensure the bevel angle and cutting edge are appropriate for your typical stock and planing tasks.