Total TAC1511141 14 X 250MM Pointed SDS Plus Chisel Bit

Specifications include: 14 mm diameter, 250 mm length, pointed tip design, and SDS Plus compatibility. The bit is described as durable and heat-treated for improved longevity, making it suitable for heavy-duty chiseling on concrete and masonry.

It’s well-suited for chiseling concrete and brick, tile removal, shaping or sculpting surfaces, and other heavy-duty demolition tasks where a pointed tip can access tight spots and create precise incisions.

1) Ensure the hammer is powered off and unplugged. 2) Insert the 14x250mm pointed SDS Plus bit into the SDS Plus chuck, fully seating it. 3) Tighten securely and set the hammer to appropriate impact mode and speed for the material. 4) Begin chiseling with steady, controlled pressure, keeping the bit perpendicular to the work surface. 5) After use, power off and remove the bit when not needed.

Wear eye protection, hearing protection, and gloves. Use a dust mask or respirator if cutting dusty concrete. Ensure the work area is clear of bystanders, and keep hands and clothing away from the rotating bit. Inspect the bit for damage before use and avoid applying excessive side loads that could cause breakage.

The TAC1511141 is described as durable with heat-treated construction and a pointed tip for precise chiseling, making it a good choice for targeted material removal. For bigger surface removal or different edge profiles, you might compare it to other pointed or flat SDS Plus chisels offered by Fepy to suit your task, such as alternatives with similar lengths or different tip geometries.

Ideal for cement or brick work, tile removal, channeling or notching in masonry, and precise demolition where a pointed tip helps access tight areas and create clean incisions.

After use, wipe clean to remove dust and debris, dry thoroughly, and store in a dry place. Inspect the cutting edges for wear or cracks before each use, and avoid overheating by using appropriate hammer settings and avoiding excessive side loads.

It’s designed for use with most SDS Plus rotary hammers. Ensure your drill/hammer supports SDS Plus bits and that the bit shank and hammer chuck fit securely. If in doubt, check your hammer’s manual for compatible bit sizes and shank types.

If you’re exploring alternatives on Fepy, you can consider similar pointed or flat SDS Plus chisels with comparable dimensions. Examples include: Total TAC1511142 14x250mm Pointed SDS Plus Chisel Bit at https://www.fepy.com/product/total-tac1511142-14x250mm-pointed-sds-plus-chisel-bit and Total TAC1511143 14x300mm Pointed SDS Plus Chisel Bit at https://www.fepy.com/product/total-tac1511143-14x300mm-pointed-sds-plus-chisel-bit. (Note: verify the exact product names and slugs on the site when browsing.)

Its combination of a durable, heat-treated build, compatibility with a wide range of SDS Plus hammers, and a 14x250mm pointed design makes it well-suited for precise, reliable chiseling on concrete and masonry tasks, potentially offering longer life and consistent performance relative to simpler or non-heat-treated bits.

Use steady, controlled pressure without forcing the bit, start with a light impact, and avoid overheating by taking breaks or alternating between tasks. Keep the bit sharp by avoiding dulling from hitting hard edges, and always store it dry and protected when not in use.