Total TAC210802 8 X 150MM Masonary Drill Bit

Key specs: 8 mm diameter, 150 mm overall length, designed for heavy-duty masonry drilling, compatible with most drills, and built for long-lasting performance in industrial, construction, and DIY tasks.

Best suited for brick, concrete, cement blocks, and other masonry substrates. It delivers clean, precise holes in hard masonry when used with a hammer drill.

This bit fits most standard drills with a chuck that can accommodate 8 mm bits and is suitable for use in hammer/drill modes that are designed for masonry work.

Insert the bit into the drill chuck, tighten securely, switch the drill to hammer/masonry mode, and start at a moderate speed with steady downward pressure. Withdraw the bit periodically to clear dust and prevent binding, and avoid overheating by not forcing the bit through the material.

Use a steady, moderate feed pressure with a hammer drill set to masonry mode. Start with a light pass to create a guide hole, then progressively increase depth while maintaining consistent speed and allowing the bit to do the work rather than forcing it.

After use, clean off dust and debris, wipe the bit dry, and store it in a dry place. Avoid exposing the bit to corrosive environments; inspect for wear and replace if the cutting edges show significant smoothing or chipping.

Wear safety glasses to protect eyes from flying debris, a dust mask for dust inhalation, and hearing protection in noisy environments. Secure your workpiece with clamps, keep hands away from the rotating bit, and ensure the drill is in good working condition.

For similar masonry drilling tasks, you can compare the TAC210802 with these alternatives on Fepy.com: TAC210801-6x100mm Masonry Drill Bit (https://fepy.com/product/tac210801-6x100mm-masonry-drill-bit) and TAC210803-8x150mm Masonry Drill Bit (https://fepy.com/product/tac210803-8x150mm-masonry-drill-bit). The TAC210801 is a smaller-diameter option for shallower holes, while TAC210803 offers the same length with an 8 mm diameter for parity in depth with a different diameter choice.

The TAC210802 provides professional-grade durability and reliable performance for heavy-duty masonry drilling, which can translate to longer tool life and fewer replacements compared with budget bits. Its value comes from performance and longevity in demanding projects.

Ideal for heavy-duty masonry work such as drilling holes for anchor bolts, sleeve anchors, electrical boxes, fasteners, and installations in brick or concrete walls and floors where deep, precise holes are required.

Yes, the TAC series on Fepy.com offers multiple diameters and lengths. If you need to drill different hole sizes or depths, you can use the corresponding TAC-series bits that match your required diameter and length (e.g., TAC210801 for 6x100mm or TAC210803 for 8x150mm).

Common use cases include anchoring heavy fixtures to masonry walls, drilling for electrical conduit or plumbing passes through masonry, and creating precise, deep holes for reinforced concrete or brick installations in both professional construction and DIY projects.