Total TAC2212301HA 9Inch X 22.2MM Depressed Centre Abrasive Metal Cutting Disc

Specifications include a 9-inch diameter, a 22.2 mm center hole, a depressed center design for flush cuts, and premium grade abrasive material. It’s built to deliver efficient cutting performance and longevity on metal materials.

Yes, it is designed to fit most standard angle grinders. Before use, verify your grinder’s arbor size and ensure it accepts a 22.2 mm center hole and that you use the correct flange and guard for safe operation.

This disc is intended for cutting metal materials, including common ferrous and non-ferrous metals encountered in metalworking tasks. Always follow tool and material guidelines for best results and safety.

Steps: 1) Ensure the grinder is unplugged or switched off. 2) Inspect the disc for cracks or damage. 3) Remove the old disc and clean the arbor. 4) Align the disc with the spindle, place the appropriate flange, and secure it with the nut. 5) Fit the guard, arm yourself with PPE, and test run at no-load before making a cut.

Operate within your grinder’s rated speed, avoid excessive pressure, and let the disc do the cutting. Keep a steady feed, maintain proper guard position, and pause if you notice glazing, heat buildup, or vibration.

Always wear appropriate PPE (eye protection, gloves, hearing protection, and a dust mask if needed). Use the grinder guard, inspect the disc for damage before each use, and avoid using damaged or overheated discs. Keep bystanders away and maintain a stable stance while cutting.

Ideal for metal fabrication tasks such as cutting bars, pipes, angle iron, structural steel, and other metal stock where a flush cut is beneficial due to the depressed center design.

Use a steady feeding rate, avoid forcing the cut, and allow the disc to cool if overheating occurs. Keep the workpiece properly secured, use the correct guard, and ensure the disc is compatible with your material to minimize surface damage and wear.

Returns are governed by Fepy’s return policy. If you’re not satisfied, you can initiate a return under the policy terms, typically within the specified window and subject to product condition and original packaging. Contact Fepy support for eligibility and steps.

You can compare it with similar 9-inch depressed-centre metal cutting discs on Fepy by exploring options such as Total TAC2212301HB and Total TAC2212301HC, which offer comparable size and design. Here are direct product pages for reference: https://fepy.com/product/total-tac2212301hb-9inch-x-22-2mm-depressed-centre-abrasive-metal-cutting-disc and https://fepy.com/product/total-tac2212301hc-9inch-x-22-2mm-depressed-centre-abrasive-metal-cutting-disc

Yes. The depressed centre design is specifically intended to enable flush cuts, reducing protrusion and enabling closer-to-material cuts when needed.